FCC ID: 2AHAS-XBS91058HP 3pc Audio Essentials Bluetooth Speaker Headphones and Earbuds Gift Set

Double Sided, Black and White XBS9-1058-SIL Manual COVER PAGE Front SAFETY AND CARE INSTRUCTIONS FCC CAUTION Do not attempt to disassemble the unit. Any changes or modifications not expressly approved by the part responsible Repairs to electrical equipment should only be performed by a qualified for compliance could void this user's authority to operate the equipment. This service person. Improper repairs may place user as risk and void warranty. | device complies with part 15 of the FCC Rules. Operation is subject to the Do not puncture or harm the exterior surface of the product in any way. following two conditions: (1) This device may not cause harmful interference, Do not drop or let the unit fall from high places, as doing so may damage and (2) this device must accept any interference received, including he device. interference that may cause undesired operation. AU DIO ESSENTIALS Do not use this unit for anything other than its intended user or purpose. Note: This equipment has been tested and found to comply with the limits for a BLUETOOTH SPEAKER, HEADPHONES & EARBUDS Doing so may damage the device and void warranty. Class B digital device, pursuant to Part 15 ofthe FCC Rules. These imits are his product is not a toy. Keep out of reach of children. designed to provide reasonable protection against harmful interference ina Do not expose batteries or battery pack to excessive heat or open flame residential installation. This equipment generates, uses and can radiate radio

' Sal frequency energy and, if notinstalled and used in accordance with the Domnot ey poseitheiniita exitemely highorlowitemperal Utesiasshiswill instructions, may cause harmful interference to radio communications. shorten the life of the device, destroy the battery, and/or distort May rtai t However, there is no guarantee that interference will not occur in a particular certain parts. installation. If this equipment does not cause harmful interference to radio or Do not use abrasive cleaning solvents to clean the unit. television reception, which can be determined by turning the equipment off n order to prolong battery life, turn off when not in use. we : and on, the user is encouraged to try to correct interference by one or more of Do not use the product if it has been damaged in any way. the following measures:

Do not use the speaker for anything other than its intended use. = Reorient or relocate the receiving antenna. Keep out of reach of children as this product is nota toy. = Increase the separation between the equipment and receiver.

= Connect the equipment into an outlet on a circuit different from that to SPECIFICATIONS which the receiver is connected. PORTABLE SPEAKER HEADPHONES MAGNETIC EARBUDS = Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement:

300mAh Battery 250mAh Battery 55mAh Battery wi protection This equipment complies with FCC radiation exposure limits set forth for an Wireless Range: 33ft Wireless Range: 33ft Charging Time: 2 Hours unconttolled.envirenmentt Charging Time: 2 Hours Charging Time: 2 Hours Play Time: 2-3 Hours ONE YEAR WARRANTY Play Time: 2-3 Hours Play Time: 2-3 Hours Electroplating finish JEM warrants its products for ONE YEAR against defects in manufacturing under regular consumer use with original receipt of retail purchase. We believe in our products and want to provide you with a replacement, if ne WHAT'S INSIDE P provide y P needed, but we have to know about the problem while the product is still Bluetooth Speaker under warranty. If you discover a defect covered by this warranty, please Headphones contact us about receiving a replacement. In order to use the products Earbuds warranty the customer must provide proof of the retailers receipt. *Any 3 x Micro USB Charging Cable customers outside of the U.S. will be responsible for shipping and handling Manual charges if a replacement is required that is not due to a manufacturing defect. JEM's warranty is limited to our products only. Our warranty does not cover the replacement or repair cost of any third-party accessory, electronic device or personal property. For instructions about how to obtain warranty service for your product, please contact Customer Service XBS9-1058-SIL 855.999.8041 POWERING YOUR AUDIO DEVICES OPERATING YOUR AUDIO DEVICES For best sound performance, please be sure battery is fully charged on your device before use. For best results (or to charge fast) do not use devices while charging. CHARGING THE BLUETOOTH PORTABLE SPEAKER o charge your Bluetooth portable speaker, connect the supplied Micro USB cable into the Micro-USB charging port and connect the other end to a USB power outlet (5V adapter not included). LED indicator will illuminate RED to indicate that the speaker is charging. Allow approximately 2 hours charging time to fully charge he speaker. When battery is fully charged, the LED will turn off. CHARGING THE BLUETOOTH HEADPHONES o charge your Bluetooth headphones, connect the supplied Micro USB cable into the Micro-USB charging port and connect the other end to a USB power outlet (5V adapter not included). The LED charging indicator will turn red, indicating that the headphones are OPERATING THE BLUETOOTH SPEAKER OPERATING THE BLUETOOTH HEADPHONES charging properly. When the LED indicator turns off, the headphones 1. Turn the Bluetooth Speaker on by switching the power switch to the 1.Turn the headphones on by holding the multi-function button Pll are fully charged (To maximize the life of the battery, do not charge ON position. The LED accent ring will flash indicating that the or 3 seconds. The LED light indicator (4) will begin flashing blue more than 2 hours). device is in pairing mode. and red. 2. Enable Bluetooth search mode on your Bluetooth enabled device 2. The headphones will enter pairing mode. Enable Bluetooth search CHARGING THE BLUETOOTH EARBUDS and select pairing name HELIX on your Bluetooth device list. Once mode on your audio device and search for pairing name ONYX and OPERATING THE BLUETOOTH EARBUDS To charge your Bluetooth earbuds, connect the supplied the speaker has successfully connected, the LED accent ring will select it on your audio device. Once the headphones have been 1.Turn the Bluetooth earbuds on by holding the iso) button for 2 Micro USB cable into the Micro-USB charging port and connect the continue to flash. successfully connected, the LED will flash blue. seconds. There will be a startup sound and the LED indicator will other end to a USB power outlet (5V adapter not included). Allow 3.To power down the Speaker, switch the power switch to the OFF 3. Press the Multifunction Button Pll to answer calls, pause and begin flashing blue and red. approximately 2 hours charging time to fully charge the earbuds. position. The LED accent ring will turn off. play and hang up call. 2. The earbuds will enter pairing mode. Enable Bluetooth search

.To change to the next track, press the PPI button mode on your audio device and search for pairing name ELECTRA

.To change to the previous track, press the I4 button and select it on your audio device. Once the earbuds has

.To raise volume, press and hold the Volume + Button successfully connected, your audio device will state that the

.To lower volume, press and hold the Volume "- " Button earbuds has been successfully connected. The LED indicator will

.To power down the headphones, hold the multi-function button PPI turn off. or 5 seconds. The LED light indicator will flash red 3 times and 3.Press the (@ button to answer calls, pause and play and hang remain off. up call. 9. To use headphones from a wired audio source, plug in a 3.5mm audio 4.To raise volume, long press Volume "+" Button . To change to the cable into the Aux port (Aux cable not included). The next track, short press the Volume +" Button. headphones will automatically switch from Bluetooth mode to 5.To lower volume, long press the Volume "-" Button. To change to Auxiliary mode. (Please note that the music controls on the the previous track short press the Volume -" Button. headphones will not function while in auxiliary mode). 6.To power down earbuds, hold the (@ button for 2 seconds, until the LED indicator will remain off.

Shenzhen Accurate Technology Co., Ltd. Project No.: RA230420-17135E-RF FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925) LABEL AND LOCATION Page 1 of 1

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel 908-222-7501 Fax: 908.222.7504 E- mail elid@xtremecables.com Attestation Letter Date: 02/17/2023 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(i) Filing FCC ID: 2AHAS-XBS91058HP JEM ACCESSORIES INC. (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Signature Contact Person: Eli Dabbah Title: Manager Company Name: JEM ACCESSORIES INC. Company Address: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 CFR 47 2.911(d)(5)(i) Attestation Letter

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel 908-222-7501 Fax: 908.222.7504 E- mail elid@xtremecables.com Attestation Letter Date: 2023/4/23 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(ii) Filing FCC ID: 2AHAS-XBS91058HP JEM ACCESSORIES INC. (the applicant) certifies that as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Signature Contact Person: Eli Dabbah Title: Manager Company Name: JEM ACCESSORIES INC. Company Address: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 QA-FR-1007-A RC 02-08-2023 CFR 47 2.911 (d)(5)(ii) Attestation Letter

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue Edison, NJ 08817,United States Tel908-222-7501 Fax: 908.222.7504 E-mailelid@xtremecables.com Date:2023/4/23 To:FEDERALCOMMUNICATIONSCOMMISSION AuthorizationandEvaluationDivision 7435OaklandMillsRoadColumbia,MD21046 We,JEMACCESSORIESINC.herebydeclarethat ProductName: 3pcAudioEssentialsBluetoothSpeakerHeadphonesandEarbudsGiftSet ModelNo.:XBH91021,XBS91058-SIL,XBS9-1058 FCCID:2AHASXBS91058HP Only support BDR (GFSK), EDR (/4-DQPSK), For EDR (8DPSK), BLE 1M/2M are disable by software. Exceptforthemanufacturer,theenduserdoesnothaveanycapabilitytomodify/changetheRF parameters.Weacknowledgethatitisthemanufacturersresponsibilitytoprovidetheradio configurationstoensurecompliancewithCommissionsrules. Sincerely, Signature:

PrintedName:EliDabbah Title:Manager

Operation Description Battery (DC 3.7V) provides energy for the Bluetooth chip (AC6925F); Crystal oscillator

(24MHz) provides the clock signal for the Bluetooth chip. Bluetooth signals get through a matching circuit, and then transmitted to the space through the antenna (2402-2480MHz). When the product is connected, the product can in two-way communication with other Bluetooth Devices, and then the devices Bluetooth module sends Bluetooth signals into space, the product receives the Bluetooth signal through an antenna, transmission to the Bluetooth chip via matching circuit. Modulation Technique: GFSK, /4-DQPSK When need charging, input USB cable, and connected to the power supply, red light on, the light will change to green light when is power up.

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel908-222-7501 Fax: 908.222.7504 E-mailelid@xtremecables.com 2023/4/23 FCC Authorization FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern:

We, JEM ACCESSORIES INC. the undersigned, hereby authorize Shenzhen Accurate Technology Co.,Ltd to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Shenzhen Accurate Technology Co.,Ltd on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature:

Printed Name: Eli Dabbah Title: Manager QA-FR-170-B

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel908-222-7501 Fax: 908.222.7504 E-mailelid@xtremecables.com FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Date:2023/4/23 ToWhomItMayConcern, ProductSimilarityDeclaration We,JEMACCESSORIESINC.herebydeclarethatwehaveaproductnamedas3pcAudioEssentials BluetoothSpeakerHeadphonesandEarbudsGiftSet,(ModelNo.:XBH91021,FCCID:2AHAS XBS91058HP)wastestedbyShenzhenAccurateTechnologyCo.,Ltd.,meanwhile,forourmarketing purpose,wewouldliketolistaseriesmodelNo.:XBS91058SIL,XBS91058onreportsandcertificate, allthemodelsareidenticalinelectrically, Andnootherchangesaremadetothem. the difference are model number. Weconfirmthatallinformationaboveistrue,andwellberesponsibleforalltheconsequences.Please contactmeifyouhaveanyquestion. Sincerely, Signature:

PrintedName:EliDabbah Title:Manager

U.S. AGENT LETTER OF ATTESTATION Date: 2023-04-23 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(7) Filing FCC ID: 2AHAS-XBS91058HP JEM ACCESSORIES INC. certifies that, as of the date of the filing of the application, JEM ACCESSORIES INC.is our designated U.S. agent for service of process for the above referenced FCC ID. JEM ACCESSORIES INC. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. JEM ACCESSORIES INC. accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced FCC ID. Designated U.S. Agent and Applicant Information:

Name: JEM ACCESSORIES INC. Address: 32 Brunswick Avenue, Edison, New Jersey, United States, 08817 FRN: 0025209164 Tel.: 908-222-7501 Email: elid@xtremecables.com Signed by (printed name): Eli Dabbah Signature: