FCC ID: 2AHAS-XCA21013-2 Wireless Keyboard

XTREME Wireless Keyboard Model: XCA2-1013-BLK What is included:

1Wireless Keyboard 1NANO USB RECEIVER(Model: XCA2-1013-BLK-dongle) Function:

-2.4gHz Wi-Fi

-COMPATIBLE WITH PC/MAC

-USB CONNECTIVITY Tech Specifications:

-Easy plug and play, no installation required

-Plug included nano receiver into your computer

-Wireless range up to 30ft

-PC and Mac compatible

-Keyboard requires 2 AAA batteries (Not included) FCC warning(Wireless Keyboard and Dongle) Important Notes:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party. Responsible for compliance could void the users authority to operate this equipment. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement:

The equipment complies with FCC Radiation exposure limits set forth for uncontrolled environment.

Shenzhen Accurate Technology Co., Ltd. Project No.: RA230529-29950E-RF FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925) LABEL AND LOCATION Page 1 of 1

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel 908-222-7501 Fax: 908.222.7504 E- mail elid@xtremecables.com Attestation Letter Date: 2023/06/21 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(i) Filing FCC ID: 2AHAS-XCA21013-2 JEM ACCESSORIES INC. (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Signature Contact Person: Eli Dabbah Title: Manager Company Name: JEM ACCESSORIES INC. Company Address: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 CFR 47 2.911(d)(5)(i) Attestation Letter

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel 908-222-7501 Fax: 908.222.7504 E- mail elid@xtremecables.com Attestation Letter Date: 2023/6/21 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(ii) Filing FCC ID: 2AHAS-XCA21013-2 JEM ACCESSORIES INC. (the applicant) certifies that as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Signature Contact Person: Eli Dabbah Title: Manager Company Name: JEM ACCESSORIES INC. Company Address: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 QA-FR-1007-A RC 02-08-2023 CFR 47 2.911 (d)(5)(ii) Attestation Letter

Operational Principle 1. CPU,HS6228 have an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology. Opration frequency is 3.5 MHz with internal RC oscillator., This chip is responsible to control RF-Baseband Transceiver(HS6228). 2. Matrix,8*18 matrix with eight input line and eighteen output line. 3. 2.4 GHz ISM Band Transceiver/Framer,HS6228 which is a low-cost,fully inegrated CMOS radio frequency(RF) transceiver block,combined with a 64-byte buffered framer block.It contains transmit,receive,VCO and PLL functions,including an on-chip channel filter and resonator. It needs an external 16MHz crystal for reference frequency;

4. ANTENNA, The antenna is typically fed from the end of the monopole section by a plated through-hole via which is in turn connected to the RF output on the 2.4GHz band. 5. Voltage Range: DC 3V from battery Channel list Channel No. Frequency

(MHz Channel No. Frequency

(MHz Channel No. Frequency

(MHz Channel No. Frequency

(MHz 1 2 3 4 5 6 7 8 9 10 2402 2404 2406 2408 2410 2412 2414 2416 2418 2420 11 12 13 14 15 16 17 18 19 20 2422 2424 2426 2428 2430 2432 2434 2436 2438 2440 21 22 23 24 25 26 27 28 29 30 2442 2444 2446 2448 2450 2452 2454 2456 2458 2460 31 32 33 34 35 36 37 38 39 40 2462 2464 2466 2468 2470 2472 2474 2476 2478 2480 Note: the device has totally 40 channels, only 16 channels selected randomly from the channel list were active to transmit at same time.

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel908-222-7501 Fax: 908.222.7504 E-mailelid@xtremecables.com FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Date: 2023/6/21 To Whom It May Concern, Product Similarity Declaration We, JEM ACCESSORIES INC. hereby declare that we have a product named as Wireless Keyboard (Model No.: XCA2-1013-BLK, FCC ID: 2AHAS-XCA21013-2) was tested by Shenzhen Accurate Technology Co.,Ltd., meanwhile, for our marketing purpose, we would like to list a series model No.:

SC-1013-BLK on reports and certificate, all the models are identical in electrically, the difference are model number. We confirm that all information above is true, and well be responsible for all the consequences. Please contact me if you have any question. Sincerely, Signature:

Printed Name: Eli Dabbah Title: Manager

JEM ACCESSORIES INC. Add: 32 Brunswick Avenue, Edison, New Jersey, United States,08817 Tel908-222-7501 Fax: 908.222.7504 E-mailelid@xtremecables.com 2023/6/21 FCC Authorization FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern:

We, JEM ACCESSORIES INC. the undersigned, hereby authorize Shenzhen Accurate Technology Co.,Ltd to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Shenzhen Accurate Technology Co.,Ltd on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature:

Printed Name: Eli Dabbah Title: Manager QA-FR-170-B

U.S. AGENT LETTER OF ATTESTATION Date: 2023-06-21 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(7) Filing FCC ID: 2AHAS-XCA21013-2 JEM ACCESSORIES INC. certifies that, as of the date of the filing of the application, JEM ACCESSORIES INC.is our designated U.S. agent for service of process for the above referenced FCC ID. JEM ACCESSORIES INC. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. JEM ACCESSORIES INC. accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced FCC ID. Designated U.S. Agent and Applicant Information:

Name: JEM ACCESSORIES INC. Address: 32 Brunswick Avenue, Edison, New Jersey, United States, 08817 FRN: 0025209164 Tel.: 908-222-7501 Email: elid@xtremecables.com Signed by (printed name): Eli Dabbah Signature: