RF Control Transmitter RF Control Transmitter User Manual YKF355-005 Remote control key introduction Appearance Key introduction on TV side Note1:
The Rew key transmits 2 different IR commands depending on the g duration of the key press. p If the REW key is pressed:
- For less than 1.0s (short key press), upon key release, the RC
), p p transmits the Rew command;
y
- For longer than 1.0s (long key g press), the RC transmits the Previous command. During the first 1.0s of key-press, no code is transmitted. At 1.1s of the key being pressed, the RC starts to transmit the Previous command until the key is released. y Note 2:
The FFWD key transmits 2 different IR commands depending on the duration of the key press of the key press. If the FFWD key is pressed:
- For less than 1.0s (short key press), upon key release, the RC transmits the FFWD command;
FFWD command;
- For longer than 1.0s (long key press), the RC transmits the Next command. During the first 1.0s of key-press, no code is transmitted At 1 1s of the key being is transmitted. At 1.1s of the key being pressed, the RC starts to transmit the Next command until the key is released. Key introduction on TV side
(3)
(2)
(1) microphone start button Voice The remote control also have voice function:
(1) How to launch the voice function?
f You may press "Voice" to start the voice.
(2) How to shut down the voice function?
t th
( ) Y
(a) You may press any key (except the voice key) k k
i to stop the voice function;
(b) Shake the remote can also stop the voice function.
(3) When you using the voice function ,please make sure that the TV side shouid be facing up.
(4) Th di t
(4) The distance between the microphone and your b t th h d i mouth should be 20-50cm. ti
(5) Press the voice key once ,can only use the f function for about 11s,but you may press the voice key i again(within the 11s) to get another 11s for voice function. t 11 b t th b k f
(6) Wh ill
(6) When you are using voice function, the pointer will be useless. th ti f t i i i This device complies Part 15 of the FCC RF Rules. Operation is subject to the following two Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference
(2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must not be co-located or operating in conjunction with any other antenna or transmitter. Caution!
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment operate the equipment.