STRIKE WIRELESS CHARGING PAD Model: SKTP1CP2 Product Specification Input: 5V/1A Output: 5V/1A 1. frequency band(s) in which the radio equipment operates;
2. maximum radio-frequency power Radio Technologies and Frequency Bands The Strike wireless charging pad incorporates the following radio technologies and supports the corresponding frequencies, as specified below:
3. DoC Hereby, Jingletek Co., Ltd. declares that the radio equipment type Strike wireless charging pad is in compliance with Directive 2014/53/EU The full test of the EU declaration of conformity is available at the following internet address:
http://jingletek.com/document/eu-declaration-of-conformity.pdf This device is compliant with RF exposure limits for general population/uncontrolled exposure specified in Council Recommendation 1999/519/EC Annex II. Federal Communications Commission (FCC) Statement Statement shall be listed in the label
(if the product is smaller than palm size, it could be listed in user manual for instead.) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device. Statement shall be listed in the manual 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the users au Radio Type Description Frequency Maximum Output other Wireless Charging
(Transmitter/ Receiver) 110kHZ-205kHz thority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
there is no guarantee that
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement:
This device was tested for E and H field to demonstrate compliance with RF exposure limits, according to FCC Standards covering human exposure to electromagnetic fields from radio devices. NCC :