User Manual Battery installation For 1:24NEW RACE CAR AND NEW CONCEPT CAR Turn the rear latch to the side and remove the top cover Remove the screws and open the battery door Insert 3 AA batteries (1.5V) and close battery door Put the screws back For Remote unit Remove the screws and open the battery door Insert 2*AA batteries (1.5V) and close battery door Put the screws back Operation procedure Put the Car on the floor and make sure the frequency docking success when the car and controller are turned on Use the remote to control the car(1:24 new race car) o The car will left go forward when you press left button(put up) o The car will right back forward when you press left button(put down) o The car will turn left when you press right button(put up) o The car will turn right when you press right button(put down ) Use the remote to control the car(concept car) o The car will left go forward when you press left button. o The car will right back forward when you press right button. o The car will turn left when you make the control turn to left. o The car will turn right when you make the control turn to right. Notes:
Please make sure the car and remote within 8~10meter range. Age Recommendation: "10+ years "and adult supervision required If you do not plan to use the car , remove the batteries From both the remote and the car. Package Include:
Car unit 1pcs Remote unit 1pcs Product dimension:
1:24 new race car Car unit: L*W*H 17.8cm*7.8cm*5.9cm Remote unit: L*W*H 11.5cm*4.5cm*28.2cm Concpet car Car unit: L*W*H 16.5cm*7.7cm*5.5cm Remote unit: L*W*H 11.5cm*4.4cm*28.9cm Description:
Remote Battery:2pc AA (Batteries not included) Toy Car Battery:3PC AA(Batteries not included) Range: 8~10 meters Duration: about 15~18 mins Suitable for children of 10 years old & up This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,(2) this device must accept any interference received, including interference that may cause undesired operation. Warning:Changers of modifications to this unit not expressly approved by the party responsible for the compliance could void the users authority to operate the equipment. interference NOTE:This equipment has been tested and found to comply with the limits for the Class B digital device,pursuant to Part,15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful equipment generates,uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation,If this equipment dose cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try correct the interference by one or more of the following measures:
installation.This residential in a Reorient or relocate the receiving antenna. Increase the separation between the equipment the receiver. Connect the equipment into an outlet on a circuit different form that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.