-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver .
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC Warning :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
160mm Wireless Power Bank Instruction Manual Specif icat ions:
Please read the following carefully before using the device to ensure safe and proper usage. Package Content:
1x Power bank 1x USB-C to USB-C cable 1x User Manual Capacity: 5000mAh/3.7V Input(USB-C): 5V/3A9V/2A12V/1.5A Output: total 22.5W Max Output(USB-C): 5V/3A9V/2.22A12V/1.67A Type-C cable: 5V/3A9V/2A12V/1.5A Lightning cable: 5V/2A Wireless: 5W/7.5W/10W/15W Max USB-C+ cable+
wireless: 5V/3A m m 0 8 Charging your device using your power bank:
IMPORTANTBefore using your power bank for the rst me, fully charge it (when powered on, all 4 status LEDs are illuminated). Connect the supplied USB-C cable (or the cable that came with your device) to the power banks USB port and to your device. Then begin charging. Use built-in Type-C cable or Lightning cable to your device. Then begin charging. During charging of your device, the four indicators will shut o one by one as your device receives power, when the power bank is low in power, the f irst LED indicator bar will f lash and go out automacally unl all the power is used up. Checking your power bank baerys charging status Momentarily press the buon on your power bank and the status LEDs will indicate its charge level. Four LEDs means that the power bank baery is fully charged, while one LED means that its almost empty. Know before you go!
Front 1 LED < 25%
2 LEDs < 50%
3 LEDs < 75%
4 LEDs < 100%
If you see no LEDS or 1 f lashing LED, the baery status is less than 10%. Please recharge the power bank. Recharging your power bank:
To recharge your power bank, use the supplied USB cable to connect its USB-C port to a USB wall charging adapter. While recharging the power bank, all LEDs are ON. If there are one or more LEDs ashing, the charging is not completed. Once the power bank is fully charged, all LEDs are illuminated. The green LED indicator will light up once the unit enters fast charging mode. NOTE: For best results, do not connect the power bank to a computers USB port. We recommend using a wall charging adapter that supports fast charging protocols such as QC or PD. Wireless charging:
Press and release the buon, place your smartphone that supports wireless charging on the magnec charger surface, the unit enters wireless charging mode. The green LED indicator will light up once the unit enters fast charging mode. To stop the wireless charging funcon, press the buon twice quickly or simply remove the smartphone. It will automacally turn o if no load is detected within 30 seconds. This wireless charger can charge smartphones with non-metal protecve case or silicone covers that are no thicker than 6mm. Security advice:
Aenon
-Incorrect usage can cause explosions / danger of chemical burns.
-Damaged baeries can cause chemical burns when they come in contact with human skin.
-Do not disassemble the item.
-Never throw the item or parts of it into f ire.
-Never expose the item to high temperature changes Hot/Cold, humidity or liquids.
-Do not use if the items or parts of it are damaged.
-Store in a clean and dry space.
-To maintain baery good health, the item should be recharged every 6 months. Baery will loose capacity when stored without charging.
-If the product gets very hot, please disconnect the item and do not use it.
-Do not put any bare metal objects on the surface of wireless charger when it is operang. Back 180 x 90mm 70g 2 MPBC500-SMS-JMT001 MPBC500 1 231120 Steven