Charging stand S13 User manual Product Introduction The Charging stand is a wireless charger used combined with Joy Album K13 made by Joy Home, Inc. Product Appearance Suitable devices Charging your Joy Album digital photo album Prepare for worry-free wireless charging. The Joy Album comes with a smart dual-surface charging stand. Connect the charging stand to a power source by using the included power cable. Then set your album on either side of the charging stand-magnets will hold it in place and it will begin charging wirelessly. Product Specification Product name operating frequency Charging stand 111-145KHz Antenna gain Antenna type Power supply 0dbi Internal type, coil antenna 100-240VAC, 50-60Hz, 0.7Amax Notice:
1. Don't steep the product and isolate liquid 2.Break the power il cleanning is needed 3.Keep use temperature between 0-34 Cleaning and maintenance Always disconnect the charger from the mains before cleaning. Clean product components with a soft, dry and lint-free cloth. Do not use chemical cleaners, scouring agents or liquids! Never immerse the device in water. The product does not contain any parts which the user can repair. In the event of a defect, replace the entire assembly. Contact the manufacturer. Disposal Do not dispose of the charger and its components in the residential waste. Follow the national disposal regulations. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
(1) This device may not cause harrnful interference
(2) This device must accept any interference received including interference that may cause undesired operation 2. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body IC STATEMENT Canadian Compliance This device complies with Innovation , Science and Economic Development Canada S licence-exempt RSSs Operation is subject to the following conditions:
1.This device may not cause harmful interference. 2.This device must accept any interference received, including interference that may cause undesired operation. Conformit la rglementation canadienne Le prsent appareil est conforme aux CNR Innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
1.lappareil ne doit pas produire de brouillage;
2.lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. This apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the interfer- ence-causing equipment standard entitled: Digital Apparatus, ICES-003 of the Canadian Department of Communications. Cet appareil numrique respecte les limites bruits radiolectriques applicables aux appareils num riques de Classe B prescrites dans la norme sur le matriel brouilleur: Appareils Numriques, NMB-003 dictee par le Ministre Canadian des Communications.