JB101 Speed Meter 2. Magnet alignment mark 2. Magnet alignment mark 1. LED indicator 1. LED indicator Install JB101 on your Bike User Manual Step1: Place sensor on left chainstay with 2 cable tie Let Logo side outwards Step5: Tilt the JB101 sensor top side closer to magnet within 5mm for better sensing performance 4. Battery ribbon 4. Battery ribbon 3. Cable tie through hole 3. Cable tie through hole 5. Rubber stand 5. Rubber stand Accessories included with your product Step2: Insert the pointed end of the cable into the locking piece, Keep cable loose to allow some adjustment of position and tilt angle. Rubber stand Cable Tie Install Battery Step 1: Remove JB101 rubber stand Step 4: LED will flashing , if battery is install correct 5mm5mm Step6: Swing rear wheel ,let the magnet pass through JB101 if LED turn on sequentially. Then tighten 2 cable tie and cut off redundant cable to finish hardware installation Step 2: pull out battery Ribbon Step 6: Push back the battery ribbon and covered with Rubber stand Note: place JB101 on chainstay close to the Rim Step3: Mount the Magnet on the spoke, place the spoke in the groove of the plastic piece Step 3: battery push into battery holder Note: The battery Anode mark should face to Logo, same direction as icon on bottom side of JB101 Step4: Move magnet to align triangle mark on JB101 , tight the screw to fix magnet position. App Device Requirement This product supports mobile phone via Bluetooth wireless technology. Please pair it with your cellular phone when using this product for the first time, system requirements as bellow:
iOS 5.0 or later. Android 6.0 or later. Built-in Bluetooth low power wireless connectivity. Pair with Cellular Phone App Step1: Enable the Cellular Phone GPS & Bluetooth Device Step2: Enable JSports App Paring Device Step 1: turn to the setup page and click select JSports Device User Manual Setup items Step 2: Turn the bike wheel Turn the crank counter-
clockwise. Setup Track Log Track Log Recording About About Step 3: Device Paired Step 3: Device Paired Device had Pairing with JSports App when Device name appeared Back to main page Pairing Bike Bike Wheel Size Display Unit Gender option Owner Age Driver Height Bike Far Away Alarm Display Language Set to Default NCC :
FCC: IMPORTANT NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiverConnect the equipment into an outlet on a circuit different from that to which the receiver is connectedConsult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.