SME-SCPCAM-TFT 1 Thank you for purchasing the W F Scope Camera with Screen Included:
Scope Carry Bag Camera 1m Micro USB Cable
*Spotting Scope sold separately*
2 Attaching to Spotting Scope Make sure grips inside rotating chucks are full open. Rotate lower rotating chuck counter-
clockwise (when viewing from bottom) to open grips. Place W F Scope camera over eyepiece of spotting scope. Scope Cameras will fit eyepieces SME with diameters in range of 1 2.25 Rotate lower rotating chuck counter-
clockwise (when viewing from top) to close grips. 3 Screen Adjustments To maximize screen visibility in different light conditions, see below options:
Tilt screen downward up to 15 by pulling forward from top of screen Use screen button to adjust screen brightness while unit is ON. Continue pressing button to cycle through the following levels: 100% >
75% > 50% > 25% > OFF Micro SD Card With a Micro SD Card installed, the Spot Shot Scope will save images and videos capture via the Spot Shot App on the Micro SD Card. Insert micro SD card while unit is OFF. Insert with bottom facing up and the notch facing the left. 4 Download the SME SpotShot APP Download the SME Spot Shot Apple App Store or Google Play Store APP from the Power on the Scope Camera Connect to the SpotShot you would any other network as network. Go to the settings on your mobile device and select SSID and Password are the Spot Shot located on the bottom of the screen for 5 seconds after the unit is powered ON. (To change the password, hold the POWER and SCREEN button for 5 seconds) Launch the App and select Connect Make sure you are connecting to correct network. If correct, select Proceed. If not, select Settings to change 5 RF exposure statement This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. This equipment meets the exemption from the routine evaluation limits in section 2.5 of RSS-102. It should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. FCC Warning FCC ID: VEP-SCPCAM-TFT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 6 IC WARNING IC: 11708A-SCPCAMTFT This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
1. Lappareil ne doit pas produire de brouillage;
2. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Limited Warranty SME Spot Shot Pro Wi-Fi Scope Cameras are covered by a One Year Limited Warranty. This Warranty covers rangefinders with manufacture defects. Normal wear & tear as well as product abuse are not covered by the warranty. This Warranty is valid only for the original owner of the Wi-Fi Scope Camera purchased from an authorized retailer. Tampering with or altering the unit will void the warranty. Any unauthorized service will void the warranty. Original sales receipt must be produced for any warranty service and a Return Authorization (RA) number must be obtained from customer service at 877-269-8490 prior to returning the product. For more information go to:
www.shootingmadeeasy.com 7 Patent Pending