Applicant: Kai Wo Trading Company FCC ID: M8KEBHPFCON KAI WO ELECTRONIC &LIGHTING ELECTRONIC BALLAST USER MANUAL FLUORESCENT LAMP BALLAST INSTALLATION INSTRUCTIONS Fluorescent ballast installation should only be attempted by persons familiar with electrical wiring procedures .If you lack knowledge of electrical wiring, you should have the ballast installed by a licensed electrician WARNING AND CAUTION Failure to mount and wire ballast and fixture in conformance with the National Electrical Code, applicable Provincial, Municipal codes, and the specific U.L. safety standards for the intended working environment may cause serious personal injury, death and/or property damage. During installation, power to ballast and fixture must be disconnected at all time. Ballast and fixture must also be grounded as a precaution against possible electrical shock. Never use in the following conditions:
1. Power supply with low voltage DC such as emergency light. 2. Dimming circuit fixtures. 3. Where water may drop on the ballast. 4. Unsuitable for application when the ballast must be turned ON and OFF frequently. 5. Electronic ballast may use on a stable source of voltage that fluctuates in wide range-AC 110V-130V,50/60Hz. 6. Suitable for PLC fluorescent Lamp. 7. This product complies with Part 18 of the FCC Rules but may cause interference to radios, television, wireless telephones, and remote controls. If interference occurs, move product away from the device or plug either into a different outlet, or move the lamp out of the sight with the remote control receiver. 8. This product could produce interference when used near 0.7V, radio, wireless remote control or maritime safety communication equipment, or other critical navigation of communication equipment operating between 0.45---30 MHZ. If interference would occur, move the lamp away from the appliance a distance of three feet or more, Or plug the lamp or the appliance into a different outlet. INSTALLATION PROCEDURES 1 The output wires are inserted into the sockets of lamps as per the diagrams requirements. 2 Make electrical connections using wire nuts. Use wiring diagram on ballast. CAUTION: To prevent shock hazard, leave no exposed wire beyond wire cut. 3 Assemble fixture and install lamps. 4 Turn power on at breaker and wall switch LI BALLAST BL BLUE BLUE YEYELLOW RED RED BALLAST MUST BE GROUNDED ONE LAMP YELLOW YELLOW RED RED WIRING DIAGRAMS ALL BALLAST MUST GROUNDED LINE TWO LAMPS LAMP LAMP LAMP TWO LAMPS BALLAST LAMP LAMP BLUE RED BLACK WHITE YELLOW YELLOW ONE LAMP LAMP YELLOW YELLOW RED or RED or