1:55 Instruction Manual
- Do not combine the use of new and old batteries.
- Do not combine the use of different types of batteries.
- Make sure the batteries are installed with the correct polarity in the battery compartment.
- Do not operate the vehicle through puddles of water, on sand, thick carpet or dusty environment that will damage the vehicle and electronic parts.
- Do not operate the vehicle with the same frequency of other player in the same area that will interfere the frequency and make the vehicle out of control.
- Do not store the transmitter and vehicle in a location of high temperature or high humidity. Do not store the product under direct sunlight.
- Do not attempt to disassemble or solder the transmitter and vehicle. Transmitter Vehicle Antenna Steering Wheel Insert the steering wheel on the transmitter.
- Twist the antenna (clockwise direction) on top of the transmitter.
~ Make sure the tranemitier's power switch is turned OFF when installing batteries.
~ Unscrew battery cover on the bottom of transmitter.
= Install 1.5 (AA) x 3 alkaling batieries into the battery compartment, make sure the positive (+) and magative (-) poles are positioned correctly.
- Replace the battery cover and tighten the screw, Size:8.125"(W) x 11.125"(H)
. button * Racha roosor will tum RED
~The RED will turn off automatically again after the vehicle has Ohen tached once y
" Charge *
Bihar indicator will turn RED and the vehicle is
[anes the saver cl. charge sextourtmeeit
= The Fee arg Sr hart autcrnalicady afer ive veicie has
+ Turn on the power switch of transmitter to CHARGE position.
: the cover of charge compartment. Lock the vehicle inside the compartment by placing the vehicle with its back points downward, matching the lock and pushing if backward, and then pressing it slightly.
+ Please refer below chart for the vehicle charging Approx. 5 minutes:
ae 10 minutes 15 minutes 3Times 6
* The recharge process cannot be repeated more than 3 times continuously that will reduce the vehicie lito. You must use new batteries to charge the vehicle twice ter the first time . of transmitter once, the rechange being recharged
- After changing, open the cover of charge compartment, ta toune hie sa a the vehicle backward and take out the vehicle with it's front points upward. Turn Left Turn Right
~ Push the button *** or *s *
to operate the vehicle's direction
+ It you find the vehicle does nat fun in straight, you can achst
+ Tum the power switch of tunamitier io - Tl the steering wheel to Bnd the operation indicator operaia the vahicie's direction
'ON postion wil tum GREEN. whee & goes, when it return. the steering alignment lever on the botiom of the vohicte,
- The supply terminals are mot lo be shori-circutted.
- Avoid water damage to transmitter and vehicle. If they get wet, stop operating immediately and wait until they completely dry.
- Do not dispose batteries in fire that may cause explosion,
= If liquid leaking from the batteries stick to your skin or clothes, wash off immediately, If liquid get into your eyes, wash your eyes with distilled water and consult a physician immediately.
= (Operntion mange in eatmated 7 meters (without interference)
+ Tum the powor switch of transmitter to
(OFF position after operation,
~ Remove ail the batteries from transmitter after playing. 1530-49 Cc FOR HOME OR OFFICE USE NOTE : This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Alles. These limits are designed to provide reasonable against harmful ina This uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmiul interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try lo correct the intefarence by one or more of the following measures :
- Reorient or relocate the recetving antenna,
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit diferent from that to which the receiver Is Tested To Comply With FCC Standards
- Consult the dealer or an experienced radio/TW technician for help, REMARK: Modifications not authorized by the manufacturer may void users authority to operate this device.