KYRM-0083 module user guide KYRM-0083 1 Introduction The purpose of this document is to provide details regarding the usage of KYRM-0083module. KYRM-0083 2 Module Overview 2.1Key Feature 2.4GHz ISM Band RF transceiver. (2.4GHz ISM RF Power supply voltage range 2.6V ~ 5V. ( 2.6V~5V) 30mm x 21mm compact size. (30mm x 21mm ) 2.2 Chip LED KYRM-0083 has a programmable dual color (red and yellow) LED for status indication purpose. KYRM-0083LED 2.3Antenna KYRM-0083 has an on-board chip antenna. i-PEX connector on the module is for test purpose only. KYRM-0083 i-PEX 1 KYRM-0083 module user guide KYRM-0083 2.4Specification 2.4 GHz ISM Band RF transceiver Expansions: GPIO, I2C, SPI, UART Lithium-ion battery power protection and charging circuit Sensitivity: -100 dBm Output power: +13.8 dBm Emission current: < 200 mA Receiving current: < 100 mA Sleep current: 0.4 uA Operating voltage: 2.6 V 5 V Transmission distance: approx. 1000m Operating environment temperature range: 0 C ~ 60 C Module size: 30 x 21mm 2.5 FCC Compliance Statements FCC Compliance Statements 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including Interference that may cause undesired operation. FCC Caution!!!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Part 15B compliance statements for digital devices:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates; uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
2 KYRM-0083 module user guide KYRM-0083 Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Note: The end product shall has the words Contains Transmitter Module FCC ID: 2AU5WKYRM-0083 OEM statement The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter must be labeled with its own FCC ID number. This includes a clearly visible label on the outside of the final product enclosure that displays the contents shown below. If the FCC ID is not visible when the equipment is installed inside another device, then the outside of the device into which the equipment is installed must also display a label referring to the enclosed equipment. The end product with this module may subject to perform FCC part 15 unintentional emission test requirement and be properly authorized. This device is intended for OEM integrator only; Chip antennas: 0.5 dBi 2.6(NCC) CCXXxxLPyyyZzW 3