manual 1, Connect kStation to network, computer connect WiFi, landing 192.168.10.1 or cable connection router, login the router IP, In login screen, enter the SSID: XXXXXXX, password: kstation, click login, kstation will be flashing green light, when long become green Said kstation on computer is already connected. 2.Kstation kbeacon control Log on to https://www.admin.bcp.io, the user name: admin, password: admin, the following figure (a).Login after the global map, can choose you need to use kstation address, (2) the diagram below 3. Computer Binding kstation, login and then click the summary - kstation Binding, click kstation Bind above button at the same time, the computer began to control kstation.The following figure 4. Click on SCAN, after completion of binding kstation start scanning attachments kbeacon, green for kbeacon, below.Kstation scanning time, ten minutes show green kbeacon normal, red represents kbeacon damage or insufficient power supply. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.