MH11 MH11 18650
-
+
4x Blink 1x 2x Blink 4x Blink 2x Blink 2. 1. Hold 5s Hold 5s
<0.5s 2x App White RGB default setting O
>10s Boost 1x O 2s
=
Green Yellow Red
!
Ledlenser GmbH & Co. KG Kronenstr. 5-7 42699 Solingen Germany Phone +49 212/5948-0 Fax +49 212/5948-200 info@ledlenser.com ledlenser.com
. 1 0 V _ 1 1 H M
. 8 1 0 2 1 1 2 1
. 6 6 2 0 A 2 1 J 1 Hold 8s Hold 10s Hold 12s MH11 1x Blink App Mode 2x Blink White Mode 3x Blink RGB Mode Memory Function
(App /White /RGB ) APP Connect App Mode 1x APP Disconnect O 1x O
>5s 1x O 5s
+1x Mode Alteration 1x On App default setting White Red/RGB White Mode
+1x
+1x
+1x
+1x 5s 5s 5s 5s 100%
Optisense 15%
Low Power
+1x Mid Power
+1x
>5s Power
+1x
>5s Blink
>5s
>5s RGB Mode 1x
+1x 5s
>5s O Red
+1x 5s
>5s O
+1x Green
+1x 5s
>5s
!
O!
1. 5V 1A 4x Blink (white or RGB)
+1x Blue 2. Red Green FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.