Remote Control & Connected Bulb User Guide 4.ON/OFF CCTW / DIM RGBW Program Button ON/OFF: Every single press turns all the lights in selected group(s) ON or OFF gradually. On/off Dim+
Quick Dim Dim-
CCT-
Group 1 Group All On/off Dim/CCT+
shift function between dim and CCT Dim/CCT-
RGB-
Group 1 Group All CCT+
Group 2 RGB+
Group 2 Status Indicator:
Remote is in Standby mode or Selected Group is OFF Selected Group is ON Finding Network Channel
(when batteries are inserted) Commisioning a bulb
(slow)
(fast) 5.Dimming Dimming: Dim the light(s) in selected group(s). UP/DOWN button:
Every press: dims the lumen step by step until max./min. Keep pressing: dims until max./min. in one time. Remark: There are totally 13 brighness diming level CCT button:
Every press: adjusts the CCT step by step until max./min(for RGBW ver. remote) Keep pressing: adjusts the CCT until max./min. in one time(for RGBW ver. remote) 6.Reset remote control to factory default Dim up Quick toggling between highest and lowest dimming level &
toggling CCT (for RGBW version) Dim down Press ON/OFF key + red program button for 3 seconds. The remote control will be reset to factory default. 1.Commissioning (Pairing) Light(s) Commissioning (Pairing) Light(s): Follow instruction below to commission new smart light(s). In case you buy new smart light(s) or the current smart light(s) are set to Factory Default. Reseting Bulb(s) Restored to factory default by switch Successfully paired to Remote Light(s) blinks twiceOnce commissioned to a remote, its no longer visible to other remotes Light(s) (Factory Default) must start On With your Remote Press and hold one of the group button for 3s that you want the light(s) to join. Remote control gets close to light about 10 cm distance for touch link. Restarted by wall switch In case of a time-out,the light(s) will turn off the radio and become a standard non-controllable light(s) Fail 2.Unpairing light(s) Press group all key 1-2 + red program button for 3 seconds that you want the light(s) to unpair. Remote control gets close to light about 10 cm distance for touch link. 3.Group Selection Press the group selection button to select the group(s) you want to control. Group 1 Group 2 All Groups ON OFF 10s 1s 1s 1s 1s 1s 10s 2s 2s 2s 2s 2s 2s Light(s) added to device list as new Blinks twice User connects light(s) to new network(remote) Starting from wall switch OFF User flips the wall switch off and on 5x over between 1-2 seconds Light(s) finishes On Factory Default on 1 second off 2 seconds on 1 second off 2 seconds on 1 second off 2 seconds o n 1 second o ff 2 seconds n 1 second o ff 2 seconds o on Or after 5 min Network close Restarted by wall switch Bulb(s) could be restored to factory default status either by remote or by wall switch. Factory default by remote is same as un -pairing Bulb(s), while by wall switch is as following. FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.