105*280mm(4 105*70mm) back ON/Off/Dim Control Buttons Remote Overview Status Indicator Program Button On/Off On/Off & Dim Control Buttons Group Selection Indicators Group Selection Buttons Dim up Quick toggling between highest and lowest dimming level Dim down Status Indicator:
Remote is in Standby mode or Selected Group is OFF Selected Group is ON Finding Network Channel
(when batteries are inserted) Commisioning a bulb
(slow)
(fast) Group Selection Indicators LEDs indicate selected group. LEDs will be OFF in standby mode. Group Selection Buttons Group 1 Group 3 Group 2 Group 4 All Groups 1.Group Selection Press the group button you want to control. e.g. For Light 1--- Press group button 1--- Group indicator on--- Now you can play Group 1 Group 3 If you want to control all bulbs please press (1-4) button. e.g. Press (1-4) button---All group indicator on----Now you can play Group 2 Group 4 All Groups 2.ON/OFF ON/OFF: Every single press turns ON or OFF all the Lights in selected group(s). 3.Dimming Dimming: Dimming the lights that already commissioned to the remote. UP/DOWN: Every single press the light up/down in selected group(s) by one level until max/min. Level is reached. Dim up Quick toggling between highest and lowest dimming level Dim down Remark: There are totally 16 brightness dimming levels. Dimming(Shortcut): Every single press toggles the light in selected group(s) between max and min, Dimming level. 4.Releasing (Un-Pairing) Lights Releasing (Un-Pairing) Lights: To release the lights that already in the certain group. Caution: All lights in this certain group will be released. To release a single light, keep other lights in the same group powered off by wall switch. Press and hold PRG-> The certain Group ID button ->release PRG Brightness is at 5%. All lights in this group are set to factory default Light is added to device list as new User connects bulb to new network Or after 5 min Blinks twice Network close Press & hold Press once Release Light finishes On Restarted by wall switch 5.Commissioning (Pairing) Lights Commissioning (Pairing) Lights: Follow instruction below to commission new smart lights. In case you buy new smart lights or the current smart lights are set to Factory Default. Successfully paired to Remote Light blinks twice,Once commissioned to a remote, its no longer visible to other remotes Fail In case of a time-out,the bulb will turn off the radio and become a standard non-controllable light Light (Factory Default) must start On With your Remote Press and hold one of the group button for 3s that you want the light to join. Restarted by wall switch 6.Reset Reset: Set remote to factory default and delete all stored data. Key combination: PRG->ON/OFF->DOWN->ON/OFF After pressing all the keys in sequence above, indicator LED will flash for 5 sec and then the remote is reset done. Remote Control User GuideRemote Control User GuideRemote Control User Guide Commission Devices FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.