TWFS-B005D User Manual 2 Description
- Model : TWFS-B005D
- WLAN : 802.11 a/b/g/n/ac
- Frequency Range : 2400MHz ~ 5835MHz Features
- Dimension : 22.5mm x 20.0mm x 2.7mm
- Temperature Range : -20 ~ +85
- Supply Voltage : VBAT 3.3V to 3.9V
- Output Power WLAN : 17.0dBm(b), 14dBm(g), 14dBm(n 2.4G), 13dBm(a), 12dBm(n 5G), 10dBm(ac)
- Interface : SDIO(WLAN) Application
- Home appliance (Outdoor Device) Dimensions Copyright. 2017. All Rights Reserved. 0 / 6 TWFS-B005D User Manual 2 Power Supply Specification One Buck regulator, multiple LDO regulators, and a power management unit(PMU) are integrated into the CYW88359. All regulators are programmable via the PMU. These blocks simplify power supply design for WLAN functions in embedded designs. A single VBAT(3.3V to 3.9V DC max) and VIO supply (1.8V to 3.3V) can be used, with all additional voltages being provided by the regulators in the CYW88359. Three control signals, BT_REG_ON, WL_REG_ON, and WPT_REG_ON(that is, WPT_1P8), are used to power-up the regulators and take the respective section out of reset. The CBUCK CLDO and LNLDO power up available. All regulators are powered down only when both BT_REG_ON an WL_REG_ON are de-asserted. The CLDO and LNLDO may be turned off/on based on the dynamic demands of the digital baseband. The CYW88359 allows for an extremely low power-consumption mode by completely shutting down the CBUCK, CLDO, and LNLDO regulators. When in this state, MEMLPLDO and LPLDO(which is a low-power linear regulator supplied by the system VIO supply) provide the CYW88359 with all the voltage it requires, further reducing leakage currents. Copyright. 2017. All Rights Reserved. 1 / 6 TWFS-B005D User Manual 2
*Boot sequence Copyright. 2017. All Rights Reserved. 2 / 6 TWFS-B005D User Manual 2 General Features TWFS-B005D satisfies the following standards 1) WLAN RF band & modulation Features Dual-band 2.4GHz and 5GHz 802.11 a/b/g/n/ac(802.11ac compliant) Dual-stream up to 866Mbps data rate Supports 20, 40 and 80MHz channels with optional SGI(256 QAM modulation) Tx and Rx low-density parity check(LDPC) Supports IEEE 802.11ac/n beamforming Supports two antennas with WLAN MIMO Supports standard SDIO V3.0 (up to SDR104 mode at 208MHz, 4-bit and 1-bit) Backward compatibility with SDIO v2.0 host interface WPA and WPA2(Personal) support for powerful encryption and authentication AES and TKIP in hardware for faster data encryption and IEEE 802.11i compatibility Reference WLAN subsystem provides Wi-Fi protected Setup(WPS) 2) WLAN MAC features Enhanced MAC for supporting IEEE 802.11ac features Transmission and reception of aggregated MPDUs(A-MPDU) for high throughput(HT) Support for power management schemes, including WMM power-save multi-
poll(PSMP) and multiphase PSMP operation Support for immediate ACK and block-ACK policies Inter-frame space timing support, including RIFS Back-off counters in hardware for supporting multiple priorities as specified in the WMM specification Timing synchronization function(TSF), network allocation vector(NAV) maintenance, and target beacon transmission time(TBTT) generation in hardware Hardware offload for AES-CCMP, legacy WPA TKIP, legacy WEP ciphers, WAPI, and support for key management Programmable independent basic service set(IBSS) or infrastructure basic service set functionality Copyright. 2017. All Rights Reserved. 3 / 6 TWFS-B005D User Manual 2 PIN Description No. Pin Name I/O Description 1 2 3 4 5 6 7 8 9 N.C. N.C. N.C. N.C.
-
-
-
-
Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) SDIO_CLK I/O SDIO clock line SDIO_CMD I/O SDIO command line SDIO_DATA3 I/O SDIO data line 3 SDIO_DATA2 I/O SDIO data line 2 SDIO_DATA1 I/O SDIO data line 1 10 SDIO_DATA0 I/O SDIO data line 0 11 N.C.
-
Not Connected (Reserved) Copyright. 2017. All Rights Reserved. 4 / 6 TWFS-B005D User Manual 2 PIN Description No. Pin Name I/O Description 12 N.C. 13 VBAT 14 VBAT 15 GND 16 N.C. 17 WL_REG_ON 18 N.C. 19 N.C. 20 N.C. 21 N.C. 22 N.C.
-
I I
-
-
I
-
-
-
-
-
Not Connected (Reserved) Positive supply
- Supply voltage : Typical 3.3V. Positive supply
- Supply voltage : Typical 3.3V. Ground Not Connected (Reserved) WLAN Power on reset(Power rail : VDDIO)
- Internal 200K pull-down Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) 23 WL_ANT_CORE0 RF WLAN RF ANT 0 24 GND 25 LPO 26 GND 27 WL_DEV_WAKE
-
I
-
I Ground Low power clock input(32.768KHz, 0V ~ 1.8V peak to peak) Ground WLAN device wake from host 28 WL_HOST_WAKE O WLAN host wake from device 29 GND
-
Ground Copyright. 2017. All Rights Reserved. 5 / 6 TWFS-B005D User Manual 2 PIN Description No. Pin Name I/O Description 30 GND
-
Ground 31 WL_ANT_CORE1 RF WLAN RF ANT 1 32 SDIO_PAD 33 N.C. 34 N.C. 35 N.C. 36 N.C. 37 VIO 38 SDIO_DIS 39 PCIE_EN 40 N.C. 41 N.C. 42 N.C. 43 N.C. 44 N.C. 45 GND 46 GND 47 GND 48 GND I
-
-
-
-
I I I
-
-
-
-
-
-
-
-
-
SDIO_PADVDDIO
:If VIO_SD=1.8Vhigh, If VIO_SD=3.3Vlow Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) BT, WLAN VDDIO supply voltage.(3.3V or 1.8V)
- BT and WLAN should be same power rail SDIO_DIABLE
: Low : SDIO Enabled, High : SDIO Disabled PCIE_ENABLE
: Low : PCIE Disabled, High : PCIE Enabled Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Not Connected (Reserved) Ground Ground Ground Ground Copyright. 2017. All Rights Reserved. 6 / 6 Regulation Information 2 Company Name : LG Inntoek Model Name : TWFS-B005D FCC ID : YZP-TWFS-B005D IC : 7414C-TWFSB005D Web Site : WWW.LGINNOTEK.COM Address : 2540 N 1st ST STE 400 SAN JOSE, CA 95131-1016
[FCC Information]
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Warning&Caution:
Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void users authority to operate the equipment. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency exposure limit. A minimum separation distance of 20 cm must be maintained between the antenna and the person for this appliance to satisfy the RF exposure requirement. Copyright. 2017. All Rights Reserved. 7 / 6 Regulation Information 2
[IC Information]
This device complies with Industry Canada license-exempt RSS standard(s). Operation in subject to The following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence(s), Son utilisation est soumise Les deux conditions suivantes: (1) cet appareil ne peut pas provoquer dinterfrences et (2) cet appareil doit accepter Toute interfrence, y compris les interfrences qui peuvent causer un mauvais fonctionnement du dispositif. This device is going to be operated in 5 150 MHz ~ 5 250 MHz frequency range, it is restricted in indoor environment only. Copyright. 2017. All Rights Reserved. 8 / 6 Regulation Information 2
[Information for OEM Integrator]
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
[End product labelling]
The label for end product must include Contains FCC ID: YZP-TWFS-B005D, Contains IC:
7414C-TWFSB005D.
[CAUTION: Exposure to Radio Frequency Radiation]
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20cm between the radiator and your body. This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. Copyright. 2017. All Rights Reserved. 9 / 6
[RED Information]
LG Innotek Co, Ltd Manufacturer LG Innotek Co., Ltd. Address 26, Hanamsandan 5beon-ro Gwangsan-gu, Gwangju, 506-731, South Korea Inchang Jeong Senior Research Eng ic.jeong@lginnotek.com Operating frequency 2.4 GHz Band 802.11b/g/n(HT20) : 2 412 MHz ~ 2 472 MHz 802.11n(HT40): 2 422 MHz ~ 2 462 MHz 5 GHz Band (5 725 MHz ~ 5 850 MHz) 802.11a/n(HT20): 5 745 MHz ~ 5 825 MHz 802.11n(HT40): 5 755 MHz ~ 5 795 MHz 802.11ac(VHT80): 5 775 MHz RF Output Power
[Antenna 0]
2.4 GHz Band 17.63 dBm(802.11b), 16.23 dBm(802.11g), 15.27 dBm(802.11n_HT20), 14.75 dBm(802.11n_HT40) 5 GHz Band (5 725 MHz ~ 5 850 MHz) 13.51 dBm(802.11a), 11.42 dBm(802.11n_HT20), 11.23 dBm(802.11ac_VHT20), 11.86 dBm(802.11n_HT40), 11.64 dBm(802.11ac_VHT40), 10.02 dBm(802.11ac_VHT80)
[Antenna 1]
2.4 GHz Band 18.54 dBm(802.11b), 16.42 dBm(802.11g), 15.33 dBm(802.11n_HT20), 14.88 dBm(802.11n_HT40) 5 GHz Band (5 725 MHz ~ 5 850 MHz) 12.69 dBm(802.11a), 10.83 dBm(802.11n_HT20), 9.76 dBm(802.11ac_VHT20), 10.66 dBm(802.11n_HT40), 10.73 dBm(802.11ac_VHT40), 9.23 dBm(802.11ac_VHT80)
[Multiple Antenna]
2.4 GHz Band 18.39 dBm(802.11n_HT20), 17.91 dBm(802.11n_HT40) 5 GHz Band (5 725 MHz ~ 5 850 MHz) 10.42 dBm(802.11n_HT20), 11.00 dBm(802.11ac_VHT20), 10.60 dBm(802.11n_HT40), 10.88 dBm(802.11ac_VHT40) 9.29 dBm(802.11ac_VHT80) LG Innotek Co, Ltd