Internal Use Only The First Partner Power Control User Manual INDEX INDEX INDEX INDEX 1. Driver Install 1. Driver Install 1. Driver Install 1. Driver Install 2. Install Program 2. Install Program 2. Install Program 2. Install Program 3. Duck Menu 3. Duck Menu 3. Duck Menu 3. Duck Menu 4. Example 4. Example 4. Example 4. Example 2011. 10. 04 1. Driver Install Internal Use Only
Copyright. 2011. All Rights Reserved. 1 / 10 1. Driver Install Internal Use Only
Copyright. 2011. All Rights Reserved. 2 / 10 1. Driver Install Internal Use Only
Copyright. 2011. All Rights Reserved. 3 / 10 1. Driver Install Internal Use Only Copyright. 2011. All Rights Reserved. 4 / 10 1. Driver Install Internal Use Only
Copyright. 2011. All Rights Reserved. 5 / 10 2. Install Program Internal Use Only
Copyright. 2011. All Rights Reserved. 6 / 10 2. Install Program Internal Use Only
Copyright. 2011. All Rights Reserved. 7 / 10 3. Duck Menu Internal Use Only
Copyright. 2011. All Rights Reserved. 8 / 10
3. Duck Menu Internal Use Only
Copyright. 2011. All Rights Reserved. 9 / 10 4. Example Internal Use Only
Copyright. 2011. All Rights Reserved. 10 / 10 4. Example Internal Use Only
Copyright. 2011. All Rights Reserved. 11 / 10 4. Example Internal Use Only
Copyright. 2011. All Rights Reserved. 12 / 10 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following Remark This radio can not be installed in host where co-located or operating in conjunction with any other antenna or transmitter. This radio must be restricted to install in host that is intended for indoor use only for 5150-5250MHZ band, Wi-Fi label is written at the end of the TV. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modi cations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may notcause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum 20 cm between the radiator and your body. IC Warning This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est autorise aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Copyright. 2011. All Rights Reserved. For label requirement when transmitter module is installed in a host, the host shall have an additional permanent label referring to the enclosed module Contains Transmitter Module FCC ID: BEJTWFMB003D