Instructions for 22 Series IP Transmitters
(
16 Function shown
) SET Button activates the Receiver and the keypad function buttons Function uttons b 4 elease crews for r attery ompartment b s c at rear. 4 x AAA Alkaline batteries Effective working range up to a distance of 60 metres (200 feet) 22 Series utton switches off STOP b the eceiver and the keypad function buttons r t LED Blinks when ransmitter is active. ON utton is pressed. b Pulses while transmitting when attery is low. b when a ransmitter t t SAFETY FEATURE
!
The ransmitter automatically transmits a signal after 30 minutes; this de-activates the eceiver and the ransmitter. STOP r t To register Transmitters to the Receiver 1. Coding into Slot 1
&
PRESS HOLD STOP
(Red) both
(Green) and SET MINIMUM for a of 5 SECONDS 1. 2. 3. 4. 5. 6.
!
7. ON SET STOP on Transmitter until LED goes Ensure Receiver is OFF Press and hold and LED on Transmitter will flash once to indicate slot 1 Turn Wait for green LED on Receiver to flash slowly SET Press and hold quickly several times Check Receiver is coded correctly by pressing SET then operating any function on Transmitter until green LED on Receiver flashes Receiver OFF F1 F2 Then PRESS
&
HOLD SET for 5 seconds 2. Coding into Slot 2 1. 2. 3. 4. 5. 6. 7. 8
. SET STOP SET ON on Transmitter until LED goes to select slot 2 the LED on Transmitter will flash twice Ensure Receiver is OFF Press and hold and LED on Transmitter will flash once to indicate slot 1 Press Turn Wait for green LED on Receiver to flash slowly SET Press and hold quickly several times Check Receiver is coded correctly by pressing SET then operating any functio n on Transmitter until green LED on Receiver flashes Receiver OFF If you have any problems please phone either your local Distributor or Lodar directly:-
U 1922 613633. US 877- 257-1581. K +44
+1-
(0) Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 22TX.0 E.A4 6