WIRELESS GAMING HEADSET WITH BLUETOOTH USER GUIDE SETUP IMPORTANT !
1 2 3 XBOX ONE To complete setup for Xbox One and enable surround sound go to:
http://bit.ly/30IQUMj FAQ The LS50 headset has two modes for volume control:
Gaming Control Mode Left volume wheel controls the level of the incoming audio from the dongle
(connected to your Xbox One). Bluetooth Control Mode Left volume wheel controls the volume level of the audiocoming from your Bluetooth device. To switch between the two control modes, press and hold the left earcup button for 1 second. http://bit.ly/2ZpBuzK HEADSET
[L]
Solid = Connected Bluetooth LED Slow Blink = Not Connected Double Blink = Pairing mode Power/Charging LED Slow Blink = Not Connected Pulsing = Charging Solid = ON/Connected/Charged Center Button Press and hold for 1 second to toggle between Bluetooth and Gaming modes Double click to check battery level Audio mute in Gaming mode Play/Pause/Answer/Hangup in Bluetooth mode Volume Wheel HEADSET
[R]
Power Button USB Charging Port Mobile 3.5mm Port Microphone Port Mic Monitoring Mic Monitor On/Off = Press and hold for 3 seconds Mic Mute Mute/Unmute = Short Press LED on Boom Mic illuminates when muted EQ/Bluetooth button Press and release to cycle through EQs Press and hold for 1 second to activate Bluetooth voice assistant Press and hold for 4 seconds for Bluetooth pairing Game / Chat Balance Bluetooth Track forward / Track back ACCESSORIES MICROPHONE 1 3 Boom Mic 2 Mic Port Cover USB Charging Cable 4 Mobile 3.5mm Cable V 5 N I I C M CHARGING Pulsing = Charging Solid = Charged V 5 N I I C M MOBILE SETUP Press and hold the EQ/BT button for 4 seconds to enter pairing mode Search for Bluetooth devices on mobile phone and choose LucidSound LS50 SUPPORT LS50XTX LS50RX IC ID: 21203-06430 IC ID: 21203-03595 FCC ID: 2AGZW06430 FCC ID: 2AGZW03595 Dongle Model No:
Headset Model No:
RF Frequency: 2.40335 GHz to 2.47935 GHz Output Power: TX = 5.83 dBm RX = 3.58 dBm Manufacturer: LucidSound, Inc. Importer: Information can be found at lucidsound.com FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with FCC SAR exposure limits set forth for an uncontrolled environment The equipment can be used in close proximity to the human body without any restrictions. Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. This device complies with FCC exposure limits set forth for an uncontrolled environment Industry Canada Statement This device complies with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
?#!*
Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0.5 cm between the radiator and your body. Cet quipement est conforme aux CNR-102 dIndustrie Canada. Cet quipement doit treinstall et utilis avec une distance mini-
male de 0.5 centimtres entre le radiateur et votrecorps. Cet metteur ne doit pas tre co-localises ou oprant en conjonction avec autreantenne ou metteur. Les antennes utilises pour cet metteur doivent tre installs etfournir une distance de sparation dau moins 0.5 centimtre de toute personne et doit pas tre co-situe ni fonctionner en conjonction avec une autre antenne ou metteur. IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0 cm between the radiator and your body. Warranty LucidSound, Inc. warrants this product to be free from defects in materials and workmanship for the warranty period. This non-trans-
ferable, 1-year limited warranty is only to you, the first end-user purchaser. If a defect covered by this warranty occurs AND you provide proof of purchase, LucidSound, Inc., at its option, will repair or replace the product at no charge (excluding shipping). The LucidSound, Inc., 1-year limited warranty is available to customers worldwide. Your sole and exclusive remedy is repair or replacement of your LucidSound product. In no event shall LucidSounds liability exceed the original purchase price of the product. This warranty does not apply to: (a) normal wear and tear or abusive use; (b) industrial, professional or commercial use; (c) if the product has been tampered with or modified. This non-transferable warranty is only valid in the region/country in which the headset was originally purchased. To receive warranty service, please contact us at:
lucidsound.com
(toll free) 888-661-4469 1-760-579-6969 2019 Lucid Sound, Inc. 5939 Darwin Ct., Suite 100, Carlsbad, CA 92008 U.S.A. Microsoft, Xbox, Xbox Sphere Design, Xbox One, and Windows are trademarks of the Microsoft group of companies. All other trademarks are the property of their respective owners. The shape and design of this product are a trade dress of Lucid Sound, Inc., its subsidiaries and affiliates. All rights reserved. All oth-
er product names and images are trademarks or registered trademarks of their respective owners. Made in China. Product features, appearance and specifications may be subject to change without notice. Please retain this information for future reference.