Rotary Remote Z3-1BRL 3 V- 10 mA CR2032 battery Works with compatible ZigbeeR LED bulbs For the complete list of compatible bulbs go to www.lutron.com/connectedbulbremote 0301869 Rev. A 12/2018 Required for Installation 1 2 Philips screwdriver
(not included) Rotary knob Rotary base Connecting to a smart bulb Insert compatible Zigbee bulb and turn ON If Using a PhilipsR Hue Bridge Search PhilipsR Hue and download the app Follow screen prompts a Settings icon Accessory setup Configure sensors & switches Add accessory b c If pairing directly to a ZigbeeR bulb
(no bridge) 6 sec 6 4 in (10 cm) 1 1 LED indicator (behind button) Button toggles lights on/off Outer ring rotates to dim lights up/down English Customer Assistance For questions concerning the installation or operation of this product, call Customer Assistance. Please provide exact model number when calling. U.S.A. and Canada: 1.844.LUTRON1 Other countries: +1.610.282.3800 Mounting to the wall switch Make sure switch is on 2 Install mounting clip 3 Attach knob to mounting clip Press mount to wallplate. Securely fasten using a Philips head screwdriver B A Battery replacement 2 Loosen screw and open battery door 3 Troubleshooting Not paired/Bulb is switched off
(2 slow blinks) 2x Pairing
(slowly fading in and out) Low battery
(Red LED blinks) Pairing successful
(blinks rapidly) Align opening with toggle. Snap knob onto mount. Slide to remove/install
+
WARNING: Risk of fire, explosion, and burns. May result in serious injury or death. DO NOT recharge, disassemble, crush, puncture, heat above 212 F (100 C) or incinerate the battery. The battery in this device contains Perchlorate material, special handling may apply. For more information, visit www.dtsc.ca.gov/hazardouswaste/perchlorate This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation. Modifications not expressly approved by Lutron Electronics Co., Inc. could void the user's authority to operate this equipment. Ce dispositif est conforme la section 15 des rglements du FCC et des standards CNR exempt de licence dIndustrie Canada. L'opration est sous rserve des deux conditions suivantes :
(1) Cet appareil ne peut causer d'interfrence nuisible, et
(2) Cet appareil doit tolrer toute interfrence, mme celle pouvant affecter son fonctionnement. Tout changement ou modification sans l'autorisation expresse de Lutron Electronics Co., Inc. pourrait annuler le droit d'utiliser cet quipement. lutron.com/fcc Hold for 6 seconds; bulb will flash Restoring Factory Defaults Tap button quickly 3x. On final tap, continue to hold button for 3 seconds. Quickly tap button 3x again. Lutron Electronics Co., Inc. 7200 Suter Road Coopersburg, PA 18036-1299 USA Lutron is a trademarks of Lutron Electronics Co., Inc., registered in the U.S. and other countries. Google and the Google logo registered trademarks of Google Inc., used with permission. Apple and the Apple logo is registered trademarks of Apple Inc. App Store is a service mark of Apple Inc. Zigbee is a trademark of Zigbee Alliance. PHILIPS is a registered trademark of Koninklijke Philips N.V.