BT PAIRING NAME Status LSBT1B-AMP Function LED Prompt tone Remark USER MANUAL Power on Press and hold power on/off button for 3s Red and Blue stays 3s Power off Press and hold power on/off button for 3s Light off Pairing Automatically into pairing mode after powered on Red stayBlue blink Power on Power off Pairing Pairing successful 1Click the pairing name from the bluetooth list on to connect 2Automatically connect to last paired device Disconnection Pairing button Play/Pause Broadcast searching 1Out of bluetooth distance(10m) 2Click the pairing name from the bluetooth list to disconnect Press and hold the pairing button for 3s to disconnect the bluetooth device and into bluetooth searching Press the power on/off button to play/pause when music is playing After maser speaker connected to bluetooth, press the pairing button into Broadcast mode. Press the pairing button on slave speaker to disconnect the Broadcast mode. Press the pairing button again on master speaker to disconnect the Broadcast mode. Broadcast paired successful Automatically into seaching mode after into broadcast mode Red and Blue stays Connected Red stayBlue blink Disconnectedpairing Red stayBlue blink Red and Blue stays Pairing None Master speaker: Red stayBlue flashes three times in five seconds Slave speaker: Red stayBlue flashes quickly Broadcast mode Turn to original status Disconnected Master speaker: Red stayBlue flashes three times in five seconds Slave speaker: Red stayBlue stay Slave speaker: Connection successful Stand by function 1After powered on, 10mins power off if no connection 2After powered on, 10mins power off if no operation after connected Light off power off Hang on/Hang up Press the power on/off button to hang on/up Bluetooth status Ring of phone Reject call Press and hold the power on/off button for 1.5s to reject the call Bluetooth status None FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
*RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.