Shape of product User Manual Front of remote Back of remote Battery of remote Side of remote Operating instruction 1. After installing the 3V button battery, connect the host power supply and press the button
. During the code matching , the lighting product will flash together with the indicator light on the remote at the same time. After flashing for a few seconds, that is mean the code-matching is successful. 2.Usage for button
: Turn on and Turn off. 3.Usage for button
: Press this button once, the lighting product changes a flash mode (solid lighting or flashing...), there are 9 modes in total , If you still press the button , the flash will not stop and continue to cycle. When the button is not pressed, the current mode is displayed. 4.Usage for button
:Set up for the lighting product on channel 1 , press once will display one of flash mold.(Similar with button
),there are 9 mold in total .Press button
, the lighting product will be lighting. Press button
,the lighting will be off. 5.The button 2,3,4 has the same control way as the button 1. Just to control the correspond lighting product . 6.The remote has 4 channels(1.2,3,4) for the lighting product , and control the flash mold for each channel separately Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. RF exposure warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter. Industry Canada (IC) CAN ICES-3 (B)/NMB-3(B) This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Cetappareilestconforme la norme RSS d'Industrie Canada. Son fonctionnementestsujet aux deux conditions suivantes:
(1) ledispositif ne doit pas produire de brouillageprjudiciable, et
(2) cedispositifdoit accepter tout brouillagereu, y compris un brouillage susceptible de provoquer un fonctionnementindsirable. IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Dclarationd'exposition aux radiations:
Cetquipementestconforme aux limitesd'exposition aux rayonnements IC tablies pour unenvironnement non contrl.