LICENSING REQUIREMENTS This equipment complies with Part 74 of the FCC Rules. A license is required for operation subjective device will be issued only to the following:
(1) A licensed of an AM, FM, TV, or intemational broadcast station or low power TV station. Low power auxiliary stations will be licensed for used with a specific broadcast or low power TV station or combination of stations licensed to the same licensee within the same community.
(2) A broadcast network entity,
() A cable television system operator who operates a cable system that produces program material for origination or access cablecasting as defined in 76.5(t)
(4) Motion picture producers as defined in 74.801.
(6). Television program producers as defined in 74.801.
(6) Licensees an conditional licensees. of stations in the Multipoint Distribution service and Multichannel Multipoint Distribution Service as defined in 21.2 of this chapter, or entities that hold an executed lease agreement with an MDS or MMDS licensee or conditional licensee or with an Instructional Television Fixed service licensee or permittee. MIGROPHONE FEATURE & SPECIFICATION HANDHELD MICROPHONE 1,Sereen Head =
2.Low Battery LED 5 3.ONOFF Sten 4.Mic Housing wr 5.Battery Housing 8. Channel Selector 7.Antenna, 8.Battery Cover TIE CLIP MICROPHONE ON/OFF Suwtch Win XUR Jack 0 joo Low Battery LED ot Antenna Channel Selector &
Gain Selector ic Unt BACK Te Cp we COVER 8 10. Mictine Selector 11. Battery Compartment NOTE TWO OR MORE THAN TWO WIRELESS MICROPHONES THAT TRANSMIT ON THE SAME, FREQUENCY CAN NOT BE USED AT THE SAME TIME & AREA. TROUBLE SHOOTING:
Pease take time to read this manual and check folowing points before operating the equipment, 1. Before connecting and operating the unt, make sure thatthe voltage ofthe supplied AC adapter conforms tothe voltage avaiable in local area. 2, Ifthe LED on light means that power supply isin need of replacement, replace new batteries and. be sure that the polarity (+)(} of battery is connected property. 3. Signal dropouts and noise may be suddenly encountered by interruption from outside, to long distance between microphone and receiver or battries a low power, In such a case, adjust receiver's antennas or change new batteries. 44. Do not drop the microphone on a hard concrete floor, nr strike the microphone head with a fist of fingers, nor blow a breath stiongly into the microphone head front 5. Toke out the batteties from microphone ifn used for along time. This will prevent from the damage that a defective leaking battery may cause. 4