NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body. Printed in China 2019 V 1.0 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. User Manual The sensor transmits signal to control panel when the The tamper protection ensures that sabotage attempts to move the sensor will result in an alarm activation. 2 7 6 3 5 4 2.LED Indicator 3.Magnet Zone Jumper:
The door sensor is set in normal zone1 as default. Please follow manual of alarm system for zone setup. 1 5 5 Door or window is opened, and the transmitter sends signal to the control panel. Installation:
1. Open the back cover of the sensor, pull out the battery tab and check the battery is fitted properly. 2. Ensure the area that the sensor will be located is clean and free from dust and moisture. Avoid mounting the sensor in areas with lots of metal or electrical wiring. 3. Use the adhesive strip to carefully mount the sensor on to the 4. Mount the magnet on to the door/ window, no more than 1cm door/window frame. from the sensor. The new-bought door sensors should be enrolled to the control panel before use. Press enroll button of control panel, trigger the sensor by moving the magnet away from the sensor. The enrolled sensors will automatically appear in the Accessories Menu in the app. You can customize the accessory name, select the zone type and also delete the accessory from the app, if required. For specified operation, please refer to the manual of alarm system. It will cause on immediate alarm if the magnet depart from the transmitter more than 2cm in arming state.
<1cm
Transmit Current:
70mA Wireless RF Frequency: FHSS 433MHz Temperature:
Humidity:
Dimensions (L x W x H): 48 x 71 x 18mm