User Manual Contents 1 .Safety Instructions
...........................................................1 2 .Product Parts
...........................................................3 3 .Function Description
..............................................................3 4 .Cleaning and Maintenance
..............................................................6 5 .Trouble Shooting
................................................................8 6 .Technical Specification
................................................................9 7 .Warranty
................................................................10 11 Notes on power cord Do not use a power supply other than the rated oltage otherwise it may cause fire electric shock etc
V tie the power cord close to Please do not arbitrarily process bend pull twist high temperature ob ects damage of power line may cause fire and electric shock etc Do not load or pinch it otherwise it may cause fire electric shock short circuit etc When the power cord or power plug is damaged do not use it when the power socket is loose otherwise it may cause fire electric shock short circuit etc Do not use wet hands to plug and pull the power cord otherwise it may cause electric shock etc Please do not replace the power cord without authori ation If it is necessary to replace it due to damage please contact US Dust on power plug or socket should be cleaned regularly e cessi e dust and moisture may cause poor insulation fire electric shock etc N o t e s o n p o w e r c o r d Warning 9 2 7 4 Safety precautions for this product In order to use this product better and prevent personal injury and material damage accidents, please read carefully and abide by the following contents in this manual. The contents below must be strictly prohibited, otherwise the machine may be damaged or the personal safety of the user may be endangered. Do not allow any paint, insecticide, alcohol or chemical to be applied to the machine surface. Otherwise, surface cracks, electric shock and fire may be caused. If there is chemical composition accumulation inside the machine, it will be released from the air outlet with the opening of the machine, which is not conducive to health. Therefore, after the use of pesticides, please fully ventilate the room. Air purifier products should not be used in flammable, explosive and corrosive gas environment. Do not touch the air inlet and outlet when the machine is running. Do not insert hands or any objects into the air inlet and outlet to avoid injury or damage to the air purifier. Do not sit or place objects on the machine, otherwise it is easy to cause accidental loss or injury. Please do not use it in bathroom or other places with water. Otherwise, it may cause fire, electric shock, failure, etc. Do not transform, decompose and repair the machine without authorization, or it may cause fire, electric shock, failure, etc. For the product and the personal safety, user must strictly operate the product according to the following content. When moving or maintaining the machine, please stop running and unplug the power plug. When not in use for a long time, please pull the power cord plug out of the socket. When the machine has peculiar smell, stop using and power off, contact after-sales personnel for inspection to avoid failure or fire. The air outlet is easy to fall into debris, please check before use to avoid children putting debris in. The air purifier should be placed at least 50 cm away from the wall or other obstacles. Children and people with disabilities must be used under the supervision of adults or their guardians. Children under supervision are not allowed to use the product as a toy. It is strictly forbidden to play on the product or trample on it at will. 1 10 Problem Cause Solution No power or response. Unpleasant smell. The unit Is not plugged into an electrical outlet. The outlet is not working properly. The power adapter is damaged. The air purifier Is defective or malfunctioning. The filter may be too dirty if it's used for a long time. Using the air purifier in moist conditions or water entered in the filter. Connect the plug to a powered electrical outlet Try plugging the air purifier into a different outlet Immediately discontinue use and contact Customer Support. Replace the filter. The air quality indicator always gets in red. Dirty filters and room air is bad. Replace the filter. The unit is defective or malfunctioning. Immediately discontinue use and contact Customer Support. The numbers have been fluctuating from 3 to 12. This PM2.5 sensor is very sensitive. Auto Mode has just been turned on. Any faulty display of the LED numbers. Unusual noise while operating. Dirty filters. Filters installed improperly. The foreign object inside the unit. Flimsy or slanted surfaces resulting in an abnormal noise and vibrations. Significantly reduced airflow. Not enough space around the unit. Surrounding area exceeds the applicable area. It means the air quality is good when the value is under 12. You need to pay attention when It goes higher than 35. Allow the air purifier to run for 5 seconds. They will change a stabilized status based on the detected air quality. Replace the air filters as instructed in the Replace the Air Filters section. Place the filter properly. Please refer to the Getting Started and Replacing the Air Filters section. Immediately discontinue use and contact Customer Support. DO NOT attempt to open the air purifier yourself. Place the air purifier on hard, flat surfaces. Ensure that there are at least 15 inches
(38 cm) between the unit and other objects. DO NOT use the air purifier outdoors. This appliance is designed for indoor use only. Poor air purification quality The air inlet or outlet is blocked. Remove objects that block the air inlet or outlet. The filter is not properly placed in housing. Properly place filter as noted in the Getting Started and Replacing the Filters section. 3 8 5 6 FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. IC warning statements:
-English Warning Statement:
RSS-GEN ISSUE 5, 8.4 User manual notice This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licenceexempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
-French Warning Statement:
RSS - Gen version 5, 8.4 avis du manuel de l'utilisateur Cet appareil contient un metteur / rcepteur sans licence conforme au RSS sans licence d'innovation, science et dveloppement conomique Canada.L'opration doit satisfaire aux deux conditions suivantes:
Cet quipement peut ne pas causer d'interfrence. L'quipement doit accepter toute interfrence, y compris toute interfrence qui pourrait entraner un fonctionnement indsirable de l'quipement. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. Cet quipement est conforme aux limites dexposition aux rayonnements nonces pour un environnement non contrl et respecte les rgles dexposition aux frquences radiolectriques (RF) CNR-102 de lIC. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Lors de l'installation et du fonctionnement de cet quipement, la distance minimale entre le radiateur et le corps doit tre de 20 cm.