NNEETT--228800 UUSSEERR MMAANNUUAALL
* CONTENTS*
1. Introduction 2. Construction 3. Installation 4. Specifications. 4.1 Electrical Spec. 4.2 Electronic Spec. 5. Caution 1. Introduction NET-280-WLS is electrical transmission system to send a high quality image by using ISM BAND 2.4GHz radio frequency. The sending image to receiver show on the monitor and can see natural color by naked eye at once. Features.
- High quality image CCD Sensor : Sony 1/4 Inch, 410,000 Pixels
- Power Save : Auto Power Off (30Sec) of sender(Handgun).
- Light weight structure : Sender's Net weight is 280g.
- Rechargeable Battery : Li-ion 7.4V, 2400mA.
- Battery safe guard circuit installed : prevention of Reversed power and over-charge
- Battery charging Alarm : Buzz or lighting of LED lamp under low battery condition
- Semi-permanent light source : High brightness White LED lamp.
- Combined type of receiver & charger
- Compact Design : easy to move and install by compact size 2. Construction 3. Installation 4. Specifications 4.1 Electrical Spec. 4.2 Electronic Spec. Parameters Specifications Unit Remarks V Ch Operating Voltage Tx Rx Li-ion, 7.4V Battery DC 12V Adaptor Operating Temperatures
-10 ~ +65 Frequency Channels Pixels 2410 2470 4 410,000 Sony CCD pixels Tx Rx Power Consumptions Antenna Recharge Times Video Output Level Video Output Impedance 6 8 Dipole(1/4) 5 CVBS 1.0 75 W Hours Vpp 5. Cautions Parameters Input Power Maximum Operating Voltage Specifications Unit Remarks Rx Tx Rx AC 110 ~ 240 8.5 13.8 V V V W Max. Storage Temperature Tx, Rx
-20 ~ 85 Max. Power Consumptions Tx Rx 8 10
- Check of Monitor NTSC or PAL
- Power Off After Using Capture To Protect High Level LED
- Install Receiver at Good Ventilation Place
- Dont Disassemble It, Except MEGA Engineer
- Dont Drop Sender/Handgun
- Only Using Adaptor Supplied By MEGA MEDICAL
- Charging Battery When Handgun Turn Off Automatically Megamedical. Co., Ltd. FCC Compliance Statement. Do Not. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void users authority to operate the equipment.