SuPer FACING INSTRU Twist dome cover counterclockwise to open. Slide battery cover/attached car off of controtler. Done cover Antenna Controtier Use a Phillips head screwdriver to detach the car from the battery cover and pedestai. Place two "AA" alkaline batteries into controller and replace battery cover. Place antenna into hole at the top of controller. Turn clockwise to secure antenna to controiler. DO NOT OVER-TIGHTEN. Pull tip of antenna to extend Antenna OPERATION INSTRUCTIONS To charge the car, open cover at the bottom of controller, Align metal nodes on controller with the nodes.on the car and piace car onto controller. The charging indicator light will turn on when car is charging. After a full charge, the light will turn off. Take car away from controller.
-To be used under adult supervision.
-To assemble by an adult
~Do not pull or shake antenna as it could be damaged The controller is full function. To make the car go, push the forward or reverse button. The car will tum left and right when the left or right button is pushed. The car will only tum left and right when itis moving in forward or reverse direction. The operating light will come on when car is in use. When indicator light becomes faint, it is time to replace batteries. While operating controller,make sure antenna is fully extended. Operating light Charging indicator Occasionally the car will sway jeft or right while moving in forward or reverse direction. To correct this, adjust the directional guide on the bottom of car as shown in the illustration below. This may need to be done a few times while operating car. For best results operate on a smooth dry surface. Radio waves control this toy and can easily be interrupted. Avoid using near phones, electrical lines or CB's. The manufacturer is net responsible for radio or TV interference caused by unauthorized modification of this Directionat guide equipment. Such modifications could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. FCC Rules also prohibit unauthorized changes or modifications to the transmitter by users. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT, SUCH MODIFICATIONS COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. Foderal Communications Commission (FCC) Requirements, Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to tadio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation betwoen the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
-Consult the dealer or an experienced radio/TV technician for help.