LED VANITY MIRROR SPEAKER INTRODUCTION Congratulations on your purchase of the LED Vanity Mirror Speaker. Please read all instructions and warnings prior to use. Keep this sheet as it contains important information for future reference. CONTENTS LED Vanity Mirror Speaker Power Adapter (DC5V, 2A) FRONT-PANEL CONTROLS Volume Up Long press to increase volume. Volume Down Long press to decrease volume. Light Power Press to turn light on, press again to dim, press again to turn light off. Play/Pause Press to play/pause music. Music will pause automatically when a call is incoming. Answer Press to answer call and press again to end call and resume music. REAR-PANEL CONTROLS Bluetooth Button Press to activate Bluetooth for pairing. Press again to turn off Bluetooth. Adapter Port Plug in a power adapter (included). CONNECTING 1. Make sure Bluetooth is enabled on your device. 2. Press the Bluetooth Button on the unit. You will hear a sound. 3. On your device, select SI MIRROR SPEAKER. You will hear a sound to indicate a device is successfully paired. 4. You are now ready to st0 NOTE: Volume is controlled by both your device and the LED Vanity Mirror Speaker. Check both if the volume is too low. 5ream your favorite music!
SAFETY WARNINGS: PLEASE READ ALL SAFETY WARNINGS BEFORE USE Not intended for children under 14 years of age. Keep out of reach of children. Use this product only for its intended use. Do not use attachments of any kind. This item has no user serviceable components. Do not disassemble. Do not expose to extreme temperatures or moisture Keep away from sources of water Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately. 2019 MerchSource, LLC. Irvine, CA 92618. All rights reserved. For technical support, please call 1-800-374121-2744 Model NO.: 1009154 Printed in China LED Vanity Mirror Speaker Power Adapter This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC s RF exposure guidelines, place the product at least 20cm from nearby persons. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE. Due to continuous product improvements, the pictures on this manual may differ slightly from the actual product. 0 0 0 0 0 0 0 8 8 6 6