Size: 148.5(W) x 210(H)mm (A5) LIMITED WARRANTY This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. LIMITED WARRANTY POWER SOURCE Insert the small plug from the supplied AC/DC Adaptor to the DC IN Jack on the rear of unit. Connect the AC/DC adaptor to a wall outlet having AC 100-240 V~, 50/60 Hz NOTE: This AC/DC Adpator is intended to be correctly orientated LOCATIONS OF CONTROLS 1. Main Unit 2. Remote Sensor 3. Screws 4. Speaker with Decorative Lights 5.Wooden Base 6.Control Buttons (On the top) 7. Front Decorative Lights L R 6 2 7 1 4 5
............ 3 3 LOCATION OF CONTROL
(Standby On/O 1. ANT (FM Antenna) 2. POWER ON/OFF Switch 3. DC IN Jack 4. LINE IN Jack 5. AUX IN Jack 6. 7. INDICATOR 8. LED Button 9. SOURCE Button 10. VOL - (Volume Down) Button 11. VOL + (Volume Up) Button T U N E - / B u t t o n 12. T U N E + / B u t t o n 13. 1 LINE IN 2 k) Button 4 LOCATION OF CONTROL (REMOTE CONTROL) 1. (Standby On/O(cid:31)) Button 2. LED ON/OFF Button 3 (Mute) Button 4. SOURCE Button 5. RESET Button 6. TUNE - / Button 7. (Play / Pause) Button 8. TUNE + / Button 9. VOL (Volume) +/- Buttons 10. TREBLE +/- Buttons 11. BASS +/- Buttons 5 ASSEMBLING METHOD ASSMBLING METHOD Supplied screwdriver Assembly the two wooden bases to the bottom of unit by the supplied assembly screws and screwdriver as the illustrated above. 6 B UTTON CELL INSTALL/ REPLACE (REM OTE CONTROL)
~ Replacing the button cell for the remote control if it is drained:
1. Push then slide out the battery tray as the illustrated below. 2. Replace the button cell by a new CR2025 button cell with the polarity "+" face up as the illustrated below and the makings on the rear of remote control. 3. Close the battery tary 1. 2. B ATTERY Follow these precautions when using a battery in this device:
PRECAUTIONS 2. Be sure to the follow the correct polarity when installing the battery as indicated in the battery compartment. A reversed battery may cause damage to the device. 4. If the batteries in the device are consumed or the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's instructions.) This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, 7. Clean the battery contacts and also those of the device prior to battery installation. 8. it can cause severe internal burn in just 2 hours and can lead to death. Keep new and used batteries it can cause se away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. EFFECTIV E D ISTANCE OF REM OTE TRANSM ITTER 1. When there is an bostacle between the unit and the transmitter, the transmitter may not operate. 2. When direct sunlight, an incandescent lamp, shines on the REMOTE SENSOR of the unit, the unit remote operation may be unstable. Remote sensor 16 Feet (5 Meter) OPERATION GENERAL OPERATION:
1. Connected the unit to AC power as instructed earlier. 2. Slide the POWER ON/OFF Switch on the rear of unit to ON position to turn the unit to Standby Mode, the Red Indicator on top of unit will illuminate. 3. Press and hold the Button on the top of unit or press the Button on the Remote Control to power on the unit from Standby Mode. The Decorative LED Lights will illuminate and the color of the indicator on the top of unit will turns to correspondence color as the playback source. 4. Press the SOURCE Button on the unit or press the SOURCE Button on the Remote Control repeatedly to switch to the desired playback mode. The color of the indicator will turn to correspondent color with your selection (see list below):
Color of Indicator:
Blue BT (Bluetooth) Teal Purple Green 5. Press the VOL +/- Buttons on the unit or Remote Control to adjust volume level as desire. 6. Press the TREBLE +/- Buttons on the Remote Control to adjust the treble (high audio frequency) level as desire. 7. Press the BASS +/- Buttons on the Remote Control to adjust the bass (low audio frequency) level as desire. LINE IN AUX IN Playback Source/Mode:
FM Radio 9. Pr 10 on speakers or front of unit. 11. Control to turn the unit to Standby Mode. The color of the indicator will turns to Red. 12. For saving energy, if you will not use the unit for an extended period of time. Slide the POWER ON/OFF Switch BT MODE:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:
1. Power on the unit and enter to BT (Bluetooth) mode as the instructed earlier. The color of the indicator on the top of unit will turns to Blue and blink. 2. Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen instructions from the external BT Device. When paired, the Blue BT Indicator will stop blinking. 3. If pairing is complete you may now play music with your external BT Device. 4. During playback:
l Press the Button on the unit or the Button on Remote Control to pause, press again to resume normal playback. Press the TUNE -/ or TUNE +/ Buttons on the unit or Remote Control to Skip tracks. l Notes:
l When the external BT Device searched the unit, our model number CHT884 will appear on the display of external BT Device. l If while pairing you are asked for a code please try "0000" or "1234". Normal operation after pairing:
1. Power on the external BT Device and enter to BT playback mode. 2. Power on the unit and enter to BT (Bluetooth) mode as the instructed earlier. The color of the indicator on the top of unit will turns to Blue and blink. 3. Wait a few seconds until the unit is automatically paired to the external BT Device. The blue indicator will stop blinking. 4. After pairing is complete you may now play music with your external BT Device. RADIO:
1. Power on the unit and enter to Radio mode as the instructed earlier. The color of the indicator on the top of unit will turns to Teal. station forward. Repeat the same procedures until the desired radio station was found and play station backward. Repeat the same procedures until the desired radio station was found and play. 4. To search the radio stations from the beginning (87.5MHz), press the RESET Button on the Remote Control then press the TUNE +/ Button. FM Antenna:
The FM Antenna wire is on the rear of unit for radio reception. If reception is weak, unwound and extended the wire or reassemble the other location of the wire to improve the radio reception. Line In:
1. Insert one of the plug from the supplied Audio Connection Cable (with 3.5mm stereo mini plugs) to the Phones Jack;
Line Out Jack or AUX Out Jack on the external Audio Player such like the MP3 Player; Discman ... etc. 2. Insert the other plug to the LINE IN Jack on the rear of unit as the illustratd below:
L R L R 9 3. Power on the unit and enter to LINE IN mode as the instructed earlier. The color of the indicator on the top of unit will turns to Purple. 4. Plays the music on the connected external Audio Player as usual. (Make sure the volume level of the external Audio Player is in high level. Otherwise, sound from this unit may weak). AUX IN:
1. Insert one end of the RCA connection cable (not supplied) to the Audio Out Jacks (RCA Type) on external Audio/Video Player such like TV; DVD Player; VCR ... etc. 2. Insert the other end to the AUX IN Jacks on the rear of unit as the illustrated below:
L R L R 10 3. Power on the unit and enter to AUX IN mode as the instructed earlier. The color of the indicator on the top of unit will turns to Green. 4. Plays the music/video on the connected external Audio/Video Player as usual. (Make sure the volume level of the external Audio/Video Player is in high level. Otherwise, sound from this unit may weak). GENERAL SPECIFICATIONS Power Source: DC 5 V, 2.5A Power Source of Remote Control: DC 3 V, 1 x CR2025 button cell (included) Radio Coverage: FM 87.5 - 108 MHz Impedance A udio Power:
Bluetooth Version:
..............
................................
.........................
.................................... 5 W per Channel (Total 10 W, RMS)
.............................. 5.0 of Speakers: 2 Ohms, 8 W x 2 ACCESSORIES 1 x Owner's Manual 1 x Remote Control ( Uses 1 x CR2025 button cell, already installed into the Remote Control) 1 x AC/DC Adaptor (Input: AC 100-240V~, 50/60 Hz , 0.4 A Max. Output DC 5 V, 2500mA ) 1 x Audio Connection Cable with 3.5mm Stereo plugs 2 x Wooden Stands 6 x Assembly Screws 1 x Screwdriver SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE 11