#355083 FM WIRELESS MICROPHONE INSTRUCTION MANUAL TO REPLACE THE BATTERY 41. PULL OUT THE BELT CLIP WITH YOUR HAND. 2. REMOVE THE SCREW ON THE BATTERY DOOR WITH A SGREW DRIVER. 3.OPEN THE BATTERY DOOR AND INSERT 2 PCS "AAA" UM-4/LROS 1.5V BATTERY WITH CORRECT POLARITY INTO THE BATTERY COMPARTMENT(SEE FIG.2). EARPHONE MIC SET 3.REPLACE THE BATTERY DOOR AND THE SCREW ON POSITION. GRpHONE CK FM WIRELESS MICROPHONE OPERATION 1.PUSH THE "ON/OFF" SWITCH TG "ON" POSITION . ON/OFF KNOB 2.PLACE THE EAR BUD INTO YOUR EAR CAREFULL AND MOVE THE MICROPHOHE ABOUT 34 INCHES CLOSE TO YOUR MOUTH. 3.PLUG THE EARHPNOE MIC SET INTO THE EARPHONE JACK. 4,PLACE YOUR FM RADIO IN AN AREA WHERE INTERFERENCE/NOISE IS MINIMAL. 5.PLACE THE FM WIRELESS MICROPHONE CLOSE TO THE RADIO TO 100, 1MHz.(NOTE:THE RADIO VOLUME SHOULD NOT BE SET MAXIMUM, YOU WILL KNOW WHEN THE FREQUENCIES MATCH AS YOU WILL HEAR EITHER A
"FEEDBACK" WHISTLE OR DEAD SILENCE FROM THE RADIO. aciaciiciia 6.SPEAK INTO THE MICROPHONE AND YOU WILL HEAR YOUR VOICE COMING QUT OF THE RADIO. 7.PUSH "ON/OFF" SWITCH TO OFF* POSITION AFTER USED.
( FIG.1) Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE:
This equipment has been tested and found to comply with limits fos a Clase B digital fcr device,pureuant to Part 15 of the FOC Rules. These Emits are designed to provide reasonable protection against harmful Interference In a residential Installation. This equipment generates, uses and cad radiate radio frequency anergy and, If not Installed and used In accordance with the Instruction, may cause harmful interference to radio communications. However, these lz no guarantee that Interference ei not occur In a particular installation. If this equipment dogs cause hanmful interferanca to radio or talevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct this interfererice by one or more of the following measures:
= Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circult diffarent from that to which the receiver Is connected.
~ Consult the dealer or an experianced radia/TV tachnictan for help. This device complies with part 16 of the FCC Rules.Oparstion ls subject fo the following two conditions: (1) this device may not cause harmful Intarference,and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: GATTERY Gon 1.8UGGEST TO CHANGE THE BATTERY BY ADULT. 2.D0 NOT TOUCH OR MODIFY THE INTERNAL COMPONENTS OTHER THAN ( FIG.2) REPLACE THE BATTERY. 3.00 NOT MIX OLD AND NEW BATTERIES. 4.D0 NOT MIX ALKALINE, STANDARD (CARBON ZINC), OR RECHARGEABLE
(NICKLE-CADMIUM) BATTERIES. 5.00 NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK.
- NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
- RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE TOY BEFORE BEING CHARGED.
- RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT SUPERVISION.
- EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TOY.
- THE SUPPLY TERMINALS ARE NOT TO BE SHORT-GIRCUITED.
- ONLY BATTERIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDED ARE TO BE USED,
= PLEASE KEEP THIS INSTRUCTION MANUAL FOR FUTURE USE.