Required End Product Labeling Any device incorporating this module must include an external, visible, permanent marking or label which states: Contains FCC ID: FI5-WL18DBMOD and Contains IC :
5056A-WL18DBMOD Obligation d'tiquetage du produit final:
Tout dispositif intgrant ce module doit comporter un externe, visible, marquage permanent ou une tiquette qui dit: "Contient IC : 5056A-WL18DBMOD Additional testing, Part 15 Subpart B disclaimer The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed. FCC This module has been tested and found to comply with the following requirements for Modular Approval. Test Modes This device uses various test mode programs for test set up which operate separate from production firmware. Host integrators should contact the grantee for assistance with test modes needed for module/host compliance test requirements. The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as shown in User manual. In the end product, the antenna(s) used with this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operation in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures. User and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying the RF exposure compliance. Part 15.247 - Operation within the bands 902-928 MHz, 2400-2483.5 MHz, and 5725-5850 MHz. Part 15.407 General technical requirements.