FCC ID: I7CAYB06724 LOW POWER TRANSMITTER

by: Microtronics Inc latest update: 2007-03-29 model: AYB06724

One grant has been issued under this FCC ID on 03/29/2007 (this is the only release in 2007 for this grantee). Public details available include frequency information, internal & external photos, and manuals. some products also feature user submitted or linked instructions, password defaults, troubleshooting guides, warrantee terms, & drivers.

permalink for this FCC identifier

search for: Repair details

from iFixIt

Replacement

on Amazon

Trade-in? Recycling locations

eg is reader-supported. when you buy through links on our site, we may earn an affiliate commission.

eg for Slack usage

all	frequencies		exhibits	applications
		manual

all exhibits 10
1 ~ 2007-03-29 10

app s				submitted / available
1	USERS MANUAL	Users Manual	pdf	183.95 KiB
1		Cover Letter(s)	pdf
1		External Photos	pdf
1		Internal Photos	pdf
1		ID Label/Location Info	pdf
1		RF Exposure Info	pdf
1		Cover Letter(s)	pdf
1		Test Report	pdf
1		Test Setup Photos	pdf
1		Parts List/Tune Up Info	pdf

exhibit
download
text

USERS MANUAL

Users Manual

pdf

183.95 KiB

2270 HIWAY 54 IOLA, KS 66749 OWNERS MANUAL FOR AYB067 CIRCUIT:

TABLE OF CONTENTS:

INFORMATION TO USER:

BLOCK DIAGRAM:

GENERAL PURPOSE HEADER:

CONNECTOR DRAWING:

FCC I.D. LABLE INFORMATION TO USER:

IF CHANGES OR MODIFICATIONS ARE DONE TO AYB067 CIRCUIT BOARD WITH OUT EXPRESSLY APPROVED BY THE PARTY RESONSIBLE FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. NOTE:THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE,PURSUANT TO PART 15 OF THE FCC RULES.THESE LIMITS ARE DESIGN TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERANCE IN A RESIDENTIAL INSTALLATION.THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS,MAY CAUSE HARMFUL INTERFERANCE TO RADIO COMMUNICATIONS.HOWEVER, THERE IS NO GUARANTEE THAT INTERFERANCE WILL NOT OCCUR IN A PATICULAR INSTALLATION.IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERANCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERANCE BY ONE OR MORE OF THE FOLLOWING MEASURES.

- REORIENT OR RELOCATE THE RECEIVING ANTENNA.

- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.

- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED. CONSULT THE DEALER OR AN EXPERIENED RADIO/TV TECHNICIAN FOR HELP. BLOCK DIAGRAM:

GENERAL PUPOSE HEADER:

SERIAL 1:

MCU PORT/PIN FUNCTION REMARKS GND PTE O/Tx D1 PTE 1/Rx D1 GENERAL PURPOSE DIGITAL I/O 3.3 VOLT LOGIC UART SERIAL 2:

MCU PORT/PIN FUNCTION REMARKS GENERAL PURPOSE DIGITAL I/O 3.3 VOLT LOGIC UART CN 1:

FUNCTION REMARKS GENERAL PURPOSE DIGITAL I/O CAN WAKE MCU FROM STOP 3 OR WAIT MODE. CAN DETECT FALLING/RISING EDGES WHEN KEYBOARD INTERRUPT IS ENABLING. GND PTC 0/Tx D2 PTC 1/Rx D2 MCU PORT/PIN PTA 0 PTA 1 PTA 2 PTA 3 PTA 4 PTA 5 PTA 6 PTA 7 PTD 0 PTD 1 PTD 2 PTD 3 PTD 4 HDR. PIN 1 2 3 HDR. PIN 1 2 3 HDR. PIN 8 7 6 5 4 3 2 1 A B C D E HDR. PIN MCU PORT/PIN FUNCTION REMARKS VCC/3.3 VOLT ANALOG INPUT OR GENERAL PUPOSE DIGITAL I/O CONNECTED TO MCU ANALOG TO DIGITAL 10 BIT A/D CONVERTER, CHANNELS 0-7. CN 3:

CN 4:

CN 5:

PTB 7 PTB 6 PTB 5 PTB 4 PTB 3 PTB 2 PTB 1 PTB 0 GND GPIO 7 GPIO 6 GPIO 5 GPIO 3 GND GND PTE 2 PTE 3 PTE 4 PTE 5 HDR. PIN MCU PORT/PIN FUNCTION REMARKS GENERAL PURPOSE DIGITALI/O ON RF. COMMUNICATES TO MCU THRU SPI PORT. HDR. PIN MCU PORT/PIN FUNCTION REMARKS SLAVE SELECT SPI MISO SPI MOIS SPI SPSCK SPI USED FOR RF AND THE PROCESSOR TO SERIAL COMMUNICATION. 1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 1 2 3 4 5 6PIN:

MCU PORT/PIN FUNCTION PTA 7,PTA 6 PTA 5,PTA 4 GND POWER GND GND ENABLE EN-3 J101 PROGRAMMING HEADER :

MCU PORT/PIN PTG 0/BK GO RESET GND NC NC VCC FUNCTION SERIAL PROGRAMMING GENERAL PUPOSE I/O GROUND RESET TO MCU NC NC PROVIDES POWER REMARKS POWER GROUND 3.5v TO 29v POWER GROUND BOARD GROUND ALLOWS UNIT TO POWER UP WHEN ON COMMUNICATES TO PROCESSOR THAT POWER SWITCH IS OFF. REMARKS ACTIVE LOW RESET. HDR. PIN 1 2 3 4 5 6 HDR. PIN 1 2 3 4 5 6 CONNECTOR DRAWING:

FCC I.D. LABLE PH-620-365-8264 MICROTRONICS, INC. FCC ID: I7CAYB06724 CANADA ID: ----------------------------------------------------

1.1INCHS 1.5 INCHS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation. S/N 0 0 0 0 0 0

		frequency	equipment class	purpose
1	2007-03-29	2403.5 ~ 2480	DXX - Part 15 Low Power Communication Device Transmitter	Original Equipment

Application Forms

app s	Applicant Information
1	Effective	2007-03-29
1	Applicant's complete, legal business name	Microtronics Inc
1	FCC Registration Number (FRN)	0014042428
1	Physical Address	8 North Washington
1		Iola, Kansas 66749
1		United States

app s	TCB Information
1	TCB Application Email Address	T******@TIMCOENGR.COM
1	TCB Scope	A2: Low Power Transmitters (except Spread Spectrum) and radar detectors operating above 1 GHz

app s	FCC ID
1	Grantee Code	I7C
1	Equipment Product Code	AYB06724

app s	Person at the applicant's address to receive grant or for contact
1	Name	R**** J****
1	Title	Vice President
1	Telephone Number	316 3********
1	Fax Number	316 3********

app s	Technical Contact
		n/a

app s	Non Technical Contact
		n/a

app s	Confidentiality (long or short term)
1	Does this application include a request for confidentiality for any portion(s) of the data contained in this application pursuant to 47 CFR § 0.459 of the Commission Rules?:	Yes
1	Long-Term Confidentiality Does this application include a request for confidentiality for any portion(s) of the data contained in this application pursuant to 47 CFR § 0.459 of the Commission Rules?:	No
1	If so, specify the short-term confidentiality release date (MM/DD/YYYY format)	05/13/2007
	if no date is supplied, the release date will be set to 45 calendar days past the date of grant.

app s	Cognitive Radio & Software Defined Radio, Class, etc
1	Is this application for software defined/cognitive radio authorization?	No
1	Equipment Class	DXX - Part 15 Low Power Communication Device Transmitter
1	Description of product as it is marketed: (NOTE: This text will appear below the equipment class on the grant)	LOW POWER TRANSMITTER
1	Related OET KnowledgeDataBase Inquiry: Is there a KDB inquiry associated with this application?	No
1	Modular Equipment Type	Does not apply
1	Purpose / Application is for	Original Equipment
1	Composite Equipment: Is the equipment in this application a composite device subject to an additional equipment authorization?	No
1	Related Equipment: Is the equipment in this application part of a system that operates with, or is marketed with, another device that requires an equipment authorization?	No
1	Is there an equipment authorization waiver associated with this application?	No
1	If there is an equipment authorization waiver associated with this application, has the associated waiver been approved and all information uploaded?	No

app s	Test Firm Name and Contact Information
1	Firm Name	Rogers Labs, Inc.
1	Name	S**** R**
1	Telephone Number	913-8********
1	Fax Number	913-8********
1	E-mail	r******@micoks.net

Equipment Specifications
	Line	Rule Parts	Grant Notes	Lower Frequency	Upper Frequency	Power Output	Tolerance	Emission Designator	Microprocessor Number
1	1	15C		2403.50000000	2480.00000000

some individual PII (Personally Identifiable Information) available on the public forms may be redacted, original source may include additional details