WIRELESS MICROPHONE LOCAL RECORDING: ( Only Support TF Card)Pairing and connecting between phone on wireless mode. Hold the REC" button until you hear a beep to start recording. Hold the
"REC" button; the sound will pause one time during the recording to complete the recording. *Please note storage device like TF card needs to be inserted before startup. PLAY RECORDING: Press the "G/M" button to switch to MP3 play mode, then double click the "REC" button to replay the last recording. DELETE RECORDING: Hold "REC" button to delete the current recording when playing recordings. ONE KEY MUTE: Hold' wireless musics. button for one key mute function when playingWIRELESSW RECORDINGPower: Hold the "G/M" button to start the PARTY MIC. Connection wireless:
enable the wireless of mobile phone, click to connect, successful connection if prompt tone is produced. Adjustvoice: Adjust the volume of the MIC and the reverberation to suitable level. RECORDING WITH MOBILE PHONEConnect the recording wire: insert the MICRO plug of the recording wire into the MICRO interface and the 3.5mm interface into the earphone jack of the mobile phone. Using the PARTY MIC software on the phone select an recording app, select your favorite song, and proceed to record. Test and save the song using the provided instructions above. SELFIE FUNCTIONPress the "G/M" button to switch from wireless modde to selfie mode; Enable wireless in the mobile phone, search "shutter", click connection; Open the photograph interface of the mobile phone, press the "M/V+" or
"M4/V-" button to take photos. * Please not systems supported are 4.2.2 or higher version for Android, or higher version for IOS system. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction