SiL3qgn00aqa ciYISCININ syonposdadoaspuruywioa weifeysuy adoaspuimywosaqnnok no, syanpoudadoaspuruywioa yooqaaey is |
adoaspurwwooysaraquid SN UM JUL}
NOUV HOVER WHEEL ROTATES FOR HOVER MODE ACTION BATTERY OPERATED
(Cand 6) NOT INCLUDED NESSES!
Ee Pez WHEEL ROTATES FOR HOVER MODE ACTION PULL LATCH DOWN TO RELEASE TOMINOD LOWIS ERPEELE
*Cycle requires 4AA batteries (not included). Remote Control requires 2 AA batteries (not included) woa'sjanpoidadodspulu MAM ey72 SSTTHUUM ISN YOOOLNO 8 HOOONI 404 SUL O2ISHINO TIAWANG TSU INIEIAOH SWIdS-
LHI NidS 4IAOH SMOMTMI LMUS Joquog aoulay x]
a}DIYBA B}9KQ JBAOY X|
L471 NIdS HINCH C STULWINUING S ee 11/4 INDOOR / OUTDOOR TIRES STUMIS
~ SPINS, HOVERING MOVER, WHEEL ROTATES FOR HOVER MODE ACTION 4 VN ea) 72007 REMOTE BATTERY INTALLATION:
On vehicle, loosen screw to release battery cover (use Phillips head screwdriver, not included). Pull latch down to release. Remove battery compartment cover. Install 2 x AA 1.5 volt batteries, Follow polarity diagram below. MSPGYGA SECURE BATTERY, COVER}
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
6 lll | 9256317
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation CAUTION:
+ Remove old batteries and replace with new batteries. Be sure to insert batteries correctly according to (+) and (-) symbols located in the battery compartment.
+ Be sure to insert batteries correctly with adult supervision and always follow the toy and battery manufacturer's instructions.
+ Do not mix old and new batteries.
+ Do not mix alkaline, standard (carbo-zine), or rechargeable (nickel-cadmium) batteries.
+ Rechargeable batteries are to be removed from the toy before being charged,
+ Non-rechargeable batteries are not to be recharged.
+ Rechargeable batteries are only to be charged under adult supervision.
+ Only batteries of the same equivalent type as recommended are to be used.
+ The supply terminals are not to be short-circuited,
+ Always remove weak or dead batteries from the product.
+ Remove batteries if the product will be stored for an extended period of time. Please retain these instructions for future reference. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection MINDSC <2PE i PRoOoOUCcCTS against harmful interference in a residential installation. This equipment generates, uses and can MINDSCOPE PRODUCTS radiate radio frequency energy and, if not installed and used in accordance with the instructions, may PO BOX 9525, GLENDALE, CA 91226 cause harmful interference to radio communications. Tested & Safe for 3+
Product and color may vary from images on package Made in Shantou, Guandong China BATCH NUMBER: 2/25/2023 DOM: 22523 However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
+ Reorient or relocate the receiving antenna. eEAag Increase the separation between the equipment and receiver. D4 SE) oP)
+ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. i 2 coe
+ Consult the dealer or an experienced radio/TV technician for help.