INSTALL RS-232C INTERFACE BOARD ACCESSORIES : screw x 3 , Installation manual NOTE :
Voltage is supplied to some parts even when the POWER switch is turned off. To prevent electric shocks, be sure to turn off the VCR and unplug the power cord when installing the RS-232C interface PCB. Read the warnings stamped or labeled in various locations on the VCR and its parts. 1. Remove the two screws securing the cover plate.
( Need not remove the top cover.) 2. To remove the cover plate, slide it to the left side and then pull it towards you. 3. Remove the cable from the cover plate. 4. Connect the cable terminal on the VCR(PCB) to the connector RE on the RS-232C PCB. 5. Insert the RS-232C PCB into the rear of VCR, as shown. 6. Slide the RS-232C PCB in the direction of the arrow. 7. On the rear of VCR, tighten the three screws that secure the RS-
232C PCB in place. For US only NOTE:
FCC ID:BGBR-9000RS This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cuase undesired operation. NOTE:
This equipment has been tested and found to comply with the limita for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures:
- Raorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. For CANADA only INFORMATION THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-
003. INFORMATION CET APPAREIL NUMRIQUE DE LA CLASSE B EST CONFORME LA NORME NMB-003 DU CANADA.