Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interferene by one of the following measures:
Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the equipment into and outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. Limited Warranty MivaTek Guarantees that every wireless doorAvindow sensor is free from physical defects in material and workmanship under normal usage for one year from the date of purchase. If the product proves defective during this one-year warranty period MivaTekwill replace it free of charge .MivaTekdoes not issue any refunds. This warranty is extended to the original end user purchase only and is not transferable. This warranty does not apply to : (1) damage to units caused by accident, dropping or abuse in handling, or any negligent usage; (2) units which have been repaired, taken apart, or modified by an unauthorized personnel; (3) units not used in accordance with instruction; (4) damages exceeding the cost of the product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost. For information on addional devices, please visit us at www.MivaTek.com DweiTsorvol 1000823 | 6B1H-21003 MiVATEK Installation & Operation Manual PNB1301 Transmitter Panic Button Introduction Thanks for choosing the MivaTek wireless transmitter of the home security device. This transmitter when door arm or disarm is opened and closed. Product Description and Specification di, Specification: Package Content:
Protocol: 433.92Mhz dpe PNB1301 Transmitter Operating Range: Up to 200 feet line of sight dpe CR2032 Lithium Battery Operating Temp.: -15C~ 60C (5F ~140F) 1pe Installation & Operation manual Battery: Panasonic CR2032 * 1PC Installation 1. Before insert the battery, put home security control into learning mode. Once put CR2032 battery into the battery compartment and push the button then LED will light 1 time, and PNB1301 Transmitter will automotive included into system. Operation 1. Opening the Transmitter push button, the Transmitter will send signal to the controller, and the LED will light 1 time. Normal operation, the LED will not light. If Transmitter is in low battery status, it will report a message to controller, and LED will flash slow. Please change the battery. On