AZ700T Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited. or one of its affiliates, and MMD Hong Kong Holding Limited. is the warrantor in relation to this product. AZ700T_37_QSG_V2.0 MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT AC~MAINS MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT V4.2 120V~60Hz;
V4.2 MUTE USB CD BT AUDIO IN TUNER PAIRING ALBUM/
PRESET REPEAT SHUFFLE DSC DBB SLEEP PROG BACKLIGHT 1. 2. 3. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable CLASS 1 LASER PRODUCT 4. Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No.50, dated June 24, 2007 MMD Hong Kong Holding Limited Units 1006-1007,10th Floor, C-Bons International Center,108 Wai Yip Street, Kwun Tong, Kowloon, Hong Kong 120V~60Hz;
FCC Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. V4.2 FCC Radiation Exposure Statement:
This equipment complies with FCC radiation expo-sure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. When using the product, keep a distance of at least 20cm from the product. 120V~60Hz;
ISED Regulatory Compliance This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :(1)Lappareil ne doit pas produire de brouillage; (2)Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. RF Exposure Compliance This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. ce matriel est conforme aux limites de dose d'exposition aux rayonnements FCC/IC nonces pour un autre environnement.cet metteur ne doit pas tre situes ou oprant conjointement avec toute autre antenne ou l'metteur Lappareil est conforme aux valeurs limites dexposition au rayonnement fixes pour lic rs-102 pour les environnements non contrls.Le dispositif doit tre install et fonctionner une distance dau moins 20 cm entre le radiateur et votre corps. 100 100 100