SMART-PTT Specification Volume -
Volume +
iOS:Channel-
Android:PTT Power PTT iOS:Channel+
Android:PTT Specification:
. Bluetooth low energy mode v4.0
. ARM Cortex M0 32 bit processor
. AES HW encryption
. Replaceable CR2032 battery for 1 year life time. 5 Buttons for PTT, iOS Channel+/-, Vol+, Vol-
. LED for power on indication. Firmware upgradeable DFU by air. Users Manual To pair your SMART-PTT with the phone(iPhone or Android), please follow these steps:
1. Power on SMART-PTT. Press PTT button for 10s until LED flash twice. Its reset to factory default. 2. Go to Zello to add PTT first. ( Its most important) 3. iPhone will ask PTT-Mxxx to pair, click YES twice. If pairing request doesnt show up in Android phone, go Settings then disable and enable Bluetooth to trigger the pairing process, if necessary, tap on PTT-Mxxx to make sure it is connected to the phone. 4. Its ready to go. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure compliance requirements, please avoid direct contact to the transmitting antenna during transmitting FCC ID XTS-SMART-PTT