Shenzhencoolwave communication Co,ltd Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
interference
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. Module Device This device is intended only for OEM integrators under the following conditions:
OEM integrator is still responsible for testing their end product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization. Without Co-located The antenna(s) used for this transmitter must not be co-located or operating in conjunction CWMRF01-A 1 Shenzhencoolwave communication Co,ltd with any other antenna or transmitter. Modular OEM Integrator Notice The final end product must be labeled in a visible area with the following: Contains TX FCC ID: BTQ170495. End Product Labeling CWMDP01 UART WIRELESS TRANSCEIVER MODULE PRODUCT BRIEF CWMDP01 UART transparent wireless transceiver module is based on the chip of Semtech XE1201Amonophonic module, which operating frequency is 300 500MHz.This kind of module adopt the design of low transmission frequencyhigh Rx sensitivity, highly satisfies with European ETSIEN300-220-1 and EN301-439-3and FCC 15.231(a),complies with the demand of wireless controlno need to apply for frequency using license. Low consumptionRx current 12MA High integration Switching time is short No need to do second development
.APPLICATIONS
RF security system
Process controlwireless sensing
Vehicle door control
keyless entrybuilding control KEY PRODUCTS SPECIFICATION CWMRF01-A 2 Shenzhencoolwave communication Co,ltd Item Frequency Voltage CWMDP01 433.92MHz 5V Sensitivity
-108dBm Modulation Speed FSK 25kbps Transmitting distance 20m Tx current Rx current 16mA 10mA Operating humidity 10%~90% relative humidity, no condensation Operating temperature
-20 ~60 CWMRF01-A 3