Dual Charging Your Rush Charge Getting Started 3 2 1 4 5 6 1 2 3 4 5 UVC LED On/Off Output 1 USB Cable:
LED Charge Meter Type-C USB Input/Output UVC display Lighting USB Input 6 7 8 9 Micro USB Input Output 2 10 Wireless charger Micro USB Lighting USB Type-C USB 9 8 10 7 When charging multiple devices with USB: output will be 1.5A Red LED: 1-25% Charged Yellow LED: 25-50% Charged Blue LED: 50-75% Charged Green LED: 75-100% Charged
* The LED lights are an approximate representation of the available battery power. USB*
3 Charge via car adapter AC Power Adapter (5V) WARNING : The battery shall not be exposed to excessive heat such as sunshine, fire, or other high temperatures, it contains polymer battery. Full Power Bank charging time is approximately 4-5 hours. Charge Power Bank by using your mobile devices charging cable or Charge Power Bank before use. Do not dispose of unit with general waste. Contains lithium polymer battery. Please return it to battery recycling collection center. For recycling center near you, call +1 352-323-3500 use the 3 in 1 charging cable included. DO NOT USE any defective charging cables A B When charging one single device: output will be 3.1A. 3 in1 charging cable RBW100UVC FOR iPHONE LIGHTING FOR iPHONE LIGHTING FOR ANDROID Micro-USB FOR ANDROID USB-Type-C Charging Your Smartphone with Power Bank Charging Your Smartphone with Wireless charging Charging Your UVC LED Rush Charge can also be used to charge iPods, MP3 players, mobile phones, smart phones, iPads, micro USB compatible tablets, electronic vaporizers, e-readers, portable gaming devices, headphones, digital cameras, camcorders, video game console controllers, portable speakers, power banks, charging cases, and much more. 3 UVC&UVA LED FOR ANDROID Micro-USB A B FOR ANDROID USB-Type-C When power bank is fully charged, the LED display will show Green 2.The display will go into sleep mode after 35s without use. SAFETY PRECAUTIONS 1.Press ON/OFF button and the RC LED display will turn on to indicate wireless charging is enabled. 3. Press ON/OFF to wake from sleep mode. Display will turn on again and wireless charging is enabled. 4. Lay phone on top of the wireless charger to charge wirelessly, as shown in photo. 1. Do not look directly at the UV light when lit to avoid eye damage;
Avoid prolonged exposure to humans and animals without protective gear and clothing. 2. Store in dry protected area to avoid moisture damage. Recommended storage temperature range is 5 to 30 and a maximum humidity of RH50%. Press the ON/OFF button for 3 seconds to turn ON the UVC led. keep 1.5--2 cm from any device you want to sanitize
(like your phones, wallets, watch, bags, headsets, eating utensils or clothing. Anything you need to disinfect). It only takes 5-10 mins!
Kills 99.9% of Germs Viruses fungus particularly for the Escherichia coli, Pseudomonas aeruginosa, Staphylococcus aureus, Candida albicans. Specification 5V/3.1A 5V/3.1A Li-Polymer/10000mAh Input Output Battery Charging time 4-5 hours Capacity 10000mAh Wiress charger 3.7W Dimension 135*71*22mm Weight 220g FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.