MOTIONACCESS, LLC automatic entrance solutions MATRiX Transmitter / Receiver Changes or modifications not expressly approved by MotionAccess could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1) Single Door Setup 2) Sequenced Doors Setup Transmitter: MAX-TX 1 The Sequence Delay is not used for single doors. It is only used for sequenced doors. Transmitter: MAX-TX 1 Set the Sequence Delay to the desired time between door "A" & "B" activations. The range of this potentiometer is 1-20 seconds. Sequence Delay Signal Output 1 2 Frequency Code 1 12 ON 2 Set Signal Output dip switch #2 to ON (up). Switch #1 is not used. 3 Set the 12 Frequency Code switches to the desired positions. This code must match the Receiver Frequency Code. Note: Dip switch "UP" is "ON". 2 Set Signal Output dip switch #2 to OFF (down). Switch #1 is not used. Sequence Delay Signal Output 1 2 Frequency Code 12 ON 1 2
*
3 Set the 12 Frequency Code switches to the desired positions. This code must match the Receiver "A"
Frequency Code. Note: Dip switch "UP" is "ON". The Receiver "B" Frequency Code is the same as "A"
except with switch #2* in the opposite position. Receiver: MAX-RX 4 Receiver: MAX-RX 4 Set the Hold ON Time to the desired duration of the activation signal. The range of this potentiometer is 1-20 seconds. Set the Hold ON Time to the desired duration of the activation signal. The range of this potentiometer is 1-20 seconds. c d V 5 2
-
8
/
c a V 6 3
-
0 1 d e s o C y l l l a m r o N n o m m o c n e p O y l l a m r o N c d V 5 2
-
8
/
c a V 6 3
-
0 1 1 n o m m o c n e p O y l l a m r o N d e s o C y l l l a m r o N c d V 5 2
-
8
/
c a V 6 3
-
0 1 1 c d V 5 2
-
8
/
c a V 6 3
-
0 1 2
*
Frequency Code Hold ON Time 12 Frequency Code Hold ON Time 12 ON ON 5 Match the 12 Frequency Code switches to the Transmitter Frequency Code. Note: Dip switch
"DOWN" is "ON". 5 For Receiver "A", match the 12 Frequency Code switches to the Transmitter Frequency Code. Note:
Dip switch "DOWN" is "ON". The Receiver "B"
Frequency Code will be the same as "A" except with switch #2* in the opposite position. Notes: The receiver antenna must protrude through the operator housing. The maximum relay capacity is 1A @
120Vac / 30Vdc. Notes: The receiver antenna must protrude through the operator housing. The maximum relay capacity is 1A @
120Vac / 30Vdc. MAXTRiX_MNL_revB For technical assistance call 866-357-8832