68012007013_a_EN.fm Page 1 Thursday, November 29, 2012 2:53 PM m Mission Critical Wireless RCU Key Fob PMLN6233 FOREWORD Product Safety and RF Exposure Compliance Before using this product, read the operating instructions for safe usage contained in the Product Safety and RF Exposure booklet enclosed with your radio. Caution
*68012007013*
68012007013-B EN MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. 2012 Motorola Solutions, Inc. All rights reserved. POWERING ON KEY FOB Slide and hold 3 sec POWERING OFF KEY FOB Slide and hold 3 sec PAIRING YOUR KEY FOB First time connection steps:
1. Verify that both the radio and the key fob are powered ON and in pairing mode. To enter pairing mode on the key fob, press and hold the Trunk button while powering up the key fob. Place the Blue Dot (touch pairing spot) of the key fob on the Blue Dot on the radio. Wireless Link Connected with radio indication is provided upon successful link establishment (refer to Subsequent Connection table). Your key fob is now ready to be used. 2. 3. 4. 5. 1 cm ATTENTION!
The radio is restricted to occupational use only to satisfy ICNIRP/FCC RF energy exposure requirements. Before using this product, read the RF energy awareness information and operating instructions in the Product Safety and RF Exposure booklet enclosed with your radio (Motorola Publication part number 6881095C98 (US) or 6864117B25 (EMEA)) to ensure compliance with RF energy exposure limits. This device complies with part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes: (1) Iappareil ne doit pas produire de brouillage, et (2) Iutilisateur de Iappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Any changes or modifications not expressly approved by Motorola may void the users authority to operate this device. Battery Information:
Battery is shipped with a nominal charge between 30% and 50%. Battery should be stored between -10 C (14 F) and 30 C (86 F) to minimize permanent capacity loss. Caution: Storing your fully charged accessory in high-temperature conditions may permanently reduce the life of the internal battery. Note: The battery is not a user replaceable part. SUBSEQUENT CONNECTION Same Radio:
If the Bluetooth link is lost, connection will be automatically re-established when the radio and key fob come within range. The minimum line-of-sight range for the key fob is 30 feet. However, the body tends to obstruct the signal, therefore the normal usage range is 6 feet around your body. New Radio:
Put the key fob in Pairing Mode by powering ON while pressing Trunk button simultaneously. Follow steps from Pairing Your Key Fob. State Not Paired LED Indication 1000 ms 100 ms Paired Successfully 2 sec Wireless Link Connected with Radio Wireless Link Disconnected from Radio 50 ms 4000 ms PROGRAMMABLE BUTTON CONTROL Refer radio CPS for button assignment. Once the key fob connects with the Radio, the Programmable Button will operate as defined in the radio CPS setting. SURVEILLANCE MODE (DARK MODE) After Connection with the Radio, if the Radio is in the Surveillance Mode the key fob shall also enter Surveillance Mode. The key fob will display LED indication before it gets Connected to the Radio and will enter Surveillance Mode 20 seconds after connection is established. The key fob will not show LED indication on Link Lost if Radio is in Surveillance Mode. Important Information:
Do not charge your accessory in temperatures below 0 C
(32 F) or above 45 C (113 F). Do not store your accessory in direct sunlight or where expected temperatures can exceed this range such as inside a parked car. Storing your fully charged accessory in high-temperature conditions may permanently reduce the life of the internal battery. Battery life may temporarily shorten in low-temperature conditions. INTRODUCTION The PMLN6233 Mission Critical Wireless RCU Key Fob is compatible with APX 2000, 3000, 4000, 5000, 6000, 7000 radios with firmware SR7.13 and above. Refer to the APX radios user manual for approved body-worn accessories. 1 Prog 1 Prog 2 Trunk Button/
Prog 5 1. Enable KEY FOB OVERVIEW Prog 3 Prog 4 Panic Button/
Prog 6 FEATURE LOCK 2. Only the PTT and the 3. Disable Volume Up/Down functionality remain functional during feature lock. BATTERY ALERTS State LED Indication Remaining Battery Life 50 ms 4000 ms 100 ms 200 ms 30 min 5 min ERROR INDICATOR 10%
3%
Error TROUBLESHOOTING If at any time the wireless connection cannot be re-established, or the key fob is operating incorrectly:
1. Power Cycle the key fob and the radio. The connection should re-establish. If the problem continues; Refer to Pairing Your Key Fob to repeat the connection process. 2. CAP OPENING/CLOSING INTERNAL FEATURE LAYOUT Micro USB Jack and Charger Battery Status Indicator Pairing Indicator Keypad Lock Position Keypad Unlock Position Power ON/OFF Blue Dot 2 b CHARGING YOUR KEY FOB Charge key fob 3 hours before using. State LED Indication a 3 Flip Open 90%
Note: Key fob should be switched off during charging operations. Use only Motorola-approved supplied charger. REPLACEMENT PART The following replacement part is available for the PMLN6233 Mission Critical Wireless RCU Key Fob:
PMLN6233A 2108-12-1699
(01)07898520334773 This equipment operates as a secondary user, so it is not entitled to protection from harmful interference, even if generated by similar equipment, and it may not cause harmful interference on systems operating as primary users. Part Number PMLN6475_ Description ASSY, BACK COVER Please contact your local Motorola Representative or Dealer for details. SOFTWARE UPGRADES Please go to the respective regional MOL links below:
1. 2. 3. EMEA - https://emeaonline.motorola.com LACR/NA - https://motonline.mot.com APAC - https://asiaonline.mot.com OPEN SOURCE SOFTWARE LEGAL NOTICES This Motorola Product contains Open Source Software. For information regarding licenses, acknowledgements, required copyright notices, and other usage terms, refer to the documentation for this Motorola Product at the respective regional MOL links as above. SUPPORT Please contact Motorola Customer Care at 1-800-422-4210 (US only),
+44 2030277499 (EMEA), (5) 257-6700, (571) 602-1111 (LACR) or 1-800-88-0089 (APAC); for ordering or any technical troubleshooting assistance. WARRANTY Motorola offers a standard one year warranty. Contact your Motorola dealer for detailed information on the standard warranty. Note: Warranty is void after customer replacement of any parts other than replacement parts listed.