Use Included USB-C cables and wall charger Product Description MULTIVOICE Standard Guide Quickstart Plug USB-C cable into the Bottom of the PAC. There will be a "click"
when fully inserted. The PAC is charging when Red. Pulsing Red and Green Pulsing Solid Green Light indicates Charge is complete Thing to check:
One Unit has a "M" in the status area. Only one PAC has the "M". Stay within Check that battery line of sight with all Units. level is above 10%. Bend the mic boom so it is rotated down far enough to activate the mic. Solutions:
1)Turn off the Unit with the issue. Turn it back on again. This can be done when the system is in use. 2)Reset the entire system. Units are off before turning Make sure all back on. The Multi-Voice full duplex system allows hands free communication use design Radio combines conference radio. with a easy to on a secure signal communication with wireless This Measurements Signal Battery Length: 3.5 in Height: 1.4 in Width: 2.4 in oz Weight: 20 Frequency:
902-928 MHz 10 Hour Operation Frequency Hopping Spread Spectrum Output Power: Over 500mW Range: Up To 3/4 Mile Line of Sight
+60c Temp: -20c Rechargeable Lithium-polymer MV-PAC
Beltpack Headset
->)) x:z. Industrial/Sports Proprietary Encryption 1600 mAh UL 1642, Compliance to US/CANADA interference, found to comply with the limits for a Class against pursuant to Part 15 is subject to the operation. cause harmful harmful interference and that received, including interference two conditions:
uses and can radiate
(1) This device does not and used in accordance of the FCC Rules. These limits protection generates, This device complies with part 15 of the FCC rules. Operation following
(2) this device must accept any interference may cause undesired Note: This equipment has been tested and device, B digital provide reasonable tion. This equipment not installed ference However, tion. If this equipment does cause harmful tion, which can be determined by turning couraged Reorient Increase the separation Connect the equipment into an outlet on a ceiver is connected. Consult between the equipment and different the interference antenna. to try to correct or relocate the dealer or an experienced with the instructions, there is no guarantee that to radio communications. radio frequency interference installa will not occur in a particular recep the equipment off and on, the user is en by one or more of the following to radio or television energy and, if may cause harmful in a residential the receiving technician interference from that to are designed for help. radio/TV receiver. circuit which the re inter to installa measures:
BUTTONS usb-c made to this equipment user's not expressly authority approved to operate the equipment. ICES-003. a la norme NMB-003 du with Canadian de la classe Best conforme Changes or modifications Warning:
Radio may void the by Multi-Voice device complies This Class B digital Cet appareil numerique Canada. Le present reils radio ntes :
doit accepter ble d'en ne doit tout brouillage compromettre
(1) l'appareil pas produire le foncti onnement. appareil est conforme aux CNR d'lndustrie Canada exempts de licence. L'exploitation est autorisee aux deux et (2) l'utilisateur aux appa suiva conditions de l'appareil applicables radioelectrique de brouillage, subi, meme si le brouillage est suscepti FCC ID: ALZM2P IC:
Model : MV2P MUL TIVOICE, MV-ONE,and marks and logos are each trademarks
(800)-604-0737 the MULTIVOICE I www.MULTIVOICE.com I MUL TIVOICE 2016 of MUL TIVOICE. I R1 .0 2023 FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types MV-Pak(FCC ID: ALZM2P) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the body is 1.546W/kg. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. IC Caution:
This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
(1)
(2) l'appareil ne doit pas produire de brouillage, et l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux apparei ls radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
brouillage est susceptible d'en compromettre le fonctionnement.