ABOUT THE RADIO SYSTEM CTX-2000 2.4GHz FHSS Technology System The following is an overview of the various functions and adjustments found on CTX-2000 radio system. It is important to read and understand about all of these functions and adjustments before driving. FUNCTIONS TRANSMITTER CTX-2000 a Steering Wheel : Control direction (Left/Right) of the RC model. Throttle Reverse Throttle Limit Switch Throttle Trigger : Control speed and direction (Forward/Brake/Backward) Steering Reverse Steering of the driving model. TH. Trim Dial ON / OFF Switch : Power ON / OFF the transmitter. ST. Trim Dial SW1 Key : Is used to synchronize the connection between the transmitter and) Ep indicator the receiver. It also serves as additional function on different model. LED Indicator : For indicating battery low, pairing in progess and normal operation. ATV : Adjust the maximum steering angle on both sides when model turns Left / Right. ST. Trim Dial: Adjust the neutral position of steering servo when model wheels are straight ahead. TH. Trim Dial : To adjust the throttle position Steering Reverse : Reverse the response direction when operating Steering Wheel. Throttle Reverse : Reverse the response direction when operating Throttle Trigger. Throttle Limit Switch : Set the max Forward Speed of the model.
* In general, user will experience under steer when making a wide turn at high speed or over steer when making sharp turn at high speed (easy to spin out). User should practice the Throttle and steering approach for different cornering at different speed or road surface. Trigger Battery Installation 1. Supplied with 4x 1.5V AA Batteries, radio can be 2. Install the batteries observing the polarity 3.Then reinstall the battery Warning:
compartment cover as the Never disassemble batteries or put the Operated a few hours. marked on battery Picture shown below. batteries in fire, chemical agents, otherwise Installation: Remove the compartment. they may cause personal injuries or property battery compartment cover damages. as shown below. Battery Disposal :
Observe corresponding regulations about wasted battery treatment regulations. 1. After running out of power, dispose of wasted batteries in designated areas far away from water supply, household areas and planted areas. 2. Submit the wasted batteries to specific recycling stations. Battery LED Indicator The LED solid on indicating that the batteries have sufficient power. When batteries voltage drops below 4 volts, LED will Flashing, batteries power is low and should be replaced. Pre-Run Check 1. Steering : Adjust the steering trim to keep J the front wheels in straight line when steering wheel remains in NEUTRAL position. 2. Throttle: Adjust the throttle trim to make the motor stop while throttle trigger at Solid ON: apy NEUTRAL position. Sufficient Power supply , H 6 * Always tun on the transmitter first. Of the wal LEDis not solid on, you need to check whether the batteries are good or incorrectly installed. suai Flashing ON:
~\*" Time to replace batteries Reversing ATV Steering Reverse: Reverse the response direction when operating steering wheel. Turning laft steering ATV enables to adjust the maximum steering angle of servo on both sides (Left wheel, the model turns right while turning right the and Right) when model makes steering. The ATV affects the sensitivity of servo. model turns left. Reducing dual rate value can lower the sensitivity of servo and reduce the same Throttle Reverse: Reverse the response direction maximum steering angle on both sides. Remember to adjust the ATV within the whan operating throttle trigger. Pushing forward adjustment range. throttle trigger the model moves backward while pulling back, the made! moves forward. If necessary you can just use a small screwdriver to adjust the responding switches. Throttle Limit Switch The slide switch to select the max forward speed: < 1 __, SF 1: Slowest awl Ue2-8 W/
2 Intermediate _ 3: Fastest NCC Warning Statement Article 12 Without permission, any company, firm or user shall not alter the frequency, increase the power, or change the characterieue and functions of the original design of the certified lower power frequency electric machinery. Article 14 The application of lower power frequency electric machineries shall not affect the navigation safety nor interfere a legal communication, if an interference is found, the service will be suspended until improvement is made and the interference no longer exists. FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. FCC Warning:
The equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the manufacturer may void the users authority to operate this device. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Limited Warranty Warranty Period: Carisma R/C warrants that the CTX-2000 (Product) will be free from original factory defects in materials and workmanship upon purchase ("Warranty Period). What is Not Covered - This warranty is not transferable and does not cover (a) cosmetic damage, (b) damage due to acts of God, accident, misuse, abuse, negligence, commercial use, or due to improper use, installation, operation or maintenance, (c) modification to any part of the Product, (d) attempted service by anyone other than a Carisma R/C authorized service center, or (e) Product not purchased from an authorized Carisma RC dealer. OTHER THAN THE EXPRESS WARRANTY ABOVE, Carisma RC MAKES NO OTHER WARRANTY OR REPRE-SENTATION, AND THREFORE DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY AND SUITABILITY FOR A PARTICULAR PURPOSE. THE PURCHASER ACKNOWLEDGES THAT THEY ALONE HAVE DETER- MINED THAT THE PRODUCT WILL MEET THE REQUIREMENTS OF THEIR INTENDED USE. Purchasers Remedy - Carisma RCs sole obligation and purchasers sole and exclusive remedy shall be that Carisma RC will, at its option, either (a) service, or (b) replace, any Product determined by Carisma RC to be defective. Carisma RC reserves the right to inspect any and all Product(s) involved in a warranty claim. Service or replacement decisions are at the sole discretion of Carisma RC. Proof of purchase is required for all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE PURCHASERS SOLE AND EXCLUSIVE REMEDY. Limitation of Liability CARISMA RC SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED IN CONTRACT, WARRANTY, TORT, NEGLIGENCE, STRICT LIABILITY OR ANY OTHER THEORY OF LIABILITY, EVEN IF CARISMA RC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Further, in no event shall the liability of Carisma RC exceed the individual price of the Product on which liability Is asserted. As Carisma RC has no control over use, setup, final assembly, modification or misuse, no liability shall be assumed nor accepted for any resulting damage or injury. By the act of use, setup or assembly, the user accepts all resulting liability. If you se the purchaser or user are not prepared to accept the liability associated with the use of the Product, purchaser is advised to return the Product immediately in new and unused condition to the place of purchase. This warranty gives you specific legal rights, and you may also have other rights which vary from country to country, or state to state. Carisma RC reserves the right to change or modify this warranty at any time without notice. Muh Ah Plastic Electronic Toys Co. LTD. Flat G, 21/ Floor, Kingsway Industrial Building, Phase 2, 173 - 175 Wo Yi Hop Road, Kwai Chung, N.T., Hong Kong. Note: For official Carisma RC spare parts, see your local hobby shop or place of purchase first. If unavailable, parts can be ordered direct at: http://www.carisma-shop.com