Certification Exhibit FCC ID: HSW-934 IC: 4492A-934 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 11-0449 Manufacturer: Cirronet, Inc. Model: WIT-934 Manual 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598 WIT934 900MHz Spread Spectrum Wireless Industrial Transceiver WIT934 Integration Guide 3079 Premiere Pkwy Ste 140 Norcross, Georgia 30097 www.cirronet.com
+1 (678) 684-2000 2000- 2005 Cirronet Inc 1 M-0934-0000 Rev A Important Regulatory Information Cirronet Product FCC ID: HSW-934 / IC 4492A-934 WIT934 Note: This unit has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense. instruction manual, may cause harmful interference the FCC and IC MPE Requirements Information to user/installer regarding FCC s Maximum Permissible Exposure (MPE) limits. Notice to users/installers using the following fixed antennas:
2 dBi Cirronet Omni092
-5 dBi ThinkWireless TWP900A
.5dBi WPANT10022-C2C Portable Device-Remote Operation This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Note that the WIT934 must be configured as a "Remote" with a maximum transmitted duty cycle of 7.4%
if it is to be used as a Portable device with any of these antennas. Mobile Devices-Access Point Operation This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. When configured for mobile operation as an Access Point, a higher transmitted duty cycle of 20.6% is allowed. 9 dBi L-Comm Yagi Mobile Devices-Access Point Operation This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2000- 2005 Cirronet Inc 2 M-0934-0000 Rev A WIT934 When configured for mobile operation as an Access Point, a higher transmitted duty cycle of 20.6% is allowed. Additional Regulatory Statements WARNING: This device operates under Part 15 of the FCC rules. Any modification to this device, not expressly authorized by RFM, Inc., may void the users authority to operate this device. FCC NOTICE: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC Notice - This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformment la rglementation d'Industrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou infrieur) approuv pour l'metteur par Industrie Canada. Dans le but de rduire les risques de brouillage radiolectrique l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonne quivalente (p.i.r.e.) ne dpasse pas l'intensit ncessaire l'tablissement d'une communication satisfaisante. This radio transmitter, IC: 4492A-934 has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Le prsent metteur radio (identifier le dispositif par son numro de certification ou son numro de modle s'il fait partie du matriel de catgorie I) a t approuv par Industrie Canada pour fonctionner avec les types d'antenne numrs ci-dessous et ayant un gain admissible maximal et l'impdance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est suprieur au gain maximal indiqu, sont strictement interdits pour l'exploitation de l'metteur. RFM/Cirronet, OMNI092, Omnidirectional Antenna, 2 dBi, 50 ohms L-Comm, HG909YE Yagi Antenna, 9 dBi, 50 ohms ThinkWireless Patch Antenna, -5 dBi, 50 ohms WP Wireless, WPANT10022-C2C, Near Omnidirectional Antenna, .5dBi, 50 ohms Canadian ICES-003 - This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of Industry Canada. 2000- 2005 Cirronet Inc 3 M-0934-0000 Rev A Le prsent appareil numerique nemet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de Classe B prescrites dans le reglement sur le brouillage radioelectrique edicte par Industrie Canada. The FCC ID label must be visible through a window, or it must be visible on an access panel, door or cover that is easily removed. If neither of the above is possible, a second label must be placed on the outside of the device that contains the following text: "Contains FCC ID: HSW-934."
WIT934 2000- 2005 Cirronet Inc 4 M-0934-0000 Rev A WIT934 WIT934 OEM module, serial connector, pins down Technical Specifications Vcc Input Range:
Operating Temp Range:
Transmit Current Receiver Current Sleep Current 1.1 1.1.1 Ordering Information 1.1.2 Power Specifications 1.1.3 RF Specifications 1.1.4 Mechanical Specifications FCC Certification type Rated RF Power Line of Sight Range Frequency range Number of Channels Receiver Sensitivity Channel data rate ACR Weight Dimensions RF Connector Mating RF Connector Data/Power Connector Mating Power Connector 3.3v to 10.0v
-40 degrees C to +70 degrees C 600 mA 100 mA
<1 mA Part 15.247, Frequency Hopping Device 24 dBm 20+ miles 902-928 MHz 37
-100 dBm 345 Kbps
>55 dBc 35 g 80.2 mm X 46.5 mm X 8.6 mm MMCX 50-0-1 MMCX 50-2-3 DIS5-108-51-L-D CLP-108-02-G-D 2000- 2005 Cirronet Inc 5 M-0934-0000 Rev A