AEROBLUETOOTH/ ML90200, ML90201, ML90202, ML90203 QIG Bluetooth Stereo Receiver AEROBLUETOOTH is an audio receiver that supports wireless music streaming function with SBC and apt-X codec. After connecting to the device via a Bluetooth USB audio dongle, user can listen to music in streaming mode. Also, the user can listen to music by connecting the audio receiver to the MP3 via a Bluetooth audio transmitter or mobile phone with Bluetooth A2DP function. 1 Receiver Features LED Indicator Audio jack MFB Audio plug Function Keys Location Keys MFB button Function Power on / off / auto shutdown function Note: It will power off if auto shutdown function enable and no connection after 10 minutes. LED indicators Color Blue LED Status Function Blue led flash 3 times (dimming LED) Blue led flash once every 3 seconds Connected Power on Blue led flash once every 2 seconds( dimming LED) Blue led flash 4 times every 2 seconds Red Red led flash 4 times every 2 seconds A2DP PLAY MODE STANDBY MODE ( Auto shutdown mode on ) STANDBY MODE ( Auto shutdown mode off ) Power off Red led flash 3 times (dimming LED) Blue led flash once every 2 seconds Low battery 2 Power on or off your audio receiver Press MFB key about 3 seconds to power on the audio receiver. When the audio receiver power on the blue led will flash 3 times and you can hear a rising tone. When audio receiver already power on, press MFB key about 3~4 seconds will power off the audio receiver. When the audio receiver power off the red led will flash 3 times and you can hear a falling tone. 3 Pairing device with your audio receiver Audio receiver will into pairing mode after power on. It is easy to pair and connect to audio receiver. Operate your Bluetooth mobile phone or other Bluetooth device to start Bluetooth function. Find the headset AreoBT, press the pairing code 0000 The blue LED is start flashing, the audio receiver is in connected mode. The audio receiver will store paired device, so you dont need pair it every time. 4 Working in A2DP mode
Short press MFB key to toggle auto shutdown function 5 Trouble shooting If the audio receiver does not work, try the following:
-Ensure connecting devices are not in low battery state
-Turn off all devices and then turn them on in order to shown in this guide
-Ensure devices are within 10 meter range
-Ensure the audio receiver is connected by check the blue LED flash Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.