Quick start manual SmartTag Ear How to attach the SmartTag Ear Put the SmartTag Ear and male part of the tag into the plier and attach to the cow's ear. Make sure the SmartTag Ear is in the correct position in the ear:
The SmartTag Ear should be on the front side of the ear. The Tag should be in the middle of the ear (not in the outside of the ear, in the auricle itself, or into any of the ear's nerves). When there is already a tag in the ear, there should be no contact in any way between the tag and the SmartTag Ear. SmartTag Ear / Quick start manual 5288215 / Version 00.001 / November 2020 / EN 1 Dairy Farming Figure1:Correct positions Figure2:Wrong positions Additional information SmartTag Ear / Quick start manual 5288215 / Version 00.001 / November 2020 / EN 2 Dairy Farming Technical specifications Specication Lithium coin cell 3,0 V (internal) Operating frequency (center) 433,3 - 434,5 MHz Max. transmit power
<1mW E.r.p. Operation temperature range
-10 to 50 C (14 to 122 F) Storage temperature range
-20 to 70 C (-4 to 158 F) Relative humidity (non-condensing)
< 93% (non-condensing) Protection against water and dirt IP67 SmartTag Ear Item Electrical supply Supply voltage Antenna Environmental Compliance Certicates and declarations Compliance Region [1]
Europe USA Canada Australia New-Zealand Certication FCC ID: CGDFERPH IC: 1444A-FERPH R-NZ All relevant certicates and declarations are available at our Business Portal: http://
www.nedap.com/livestockmanagement-portal.
[1] All relevant certicates and declarations are available at our Business Portal: https://www.nedap.com/livestockmanagement-portal FCC and ISED Compliance statement This device complies with part 15 of the FCC Rules and with RSS-210 of Innovation, Science and Economic Development Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Cet appareil se conforme aux normes CNR-210 exempts de license d'Innovation, Sciences et Dveloppement conomique Canada. L'opration est soumis aux deux conditions suivantes: (1) cet appareil ne doit causer aucune interfrence, et (2) cet appareil doit accepter n'importe quelle interfrence, y inclus interfrence qui peut causer une operation non pas voulu de cet appareil. Les changements ou modications n'ayant pas t expressment approuvs par la partie responsable de la conformit peuvent faire perdre l'utilisateur l'autorisation de faire fonctionner le matriel. SmartTag Ear / Quick start manual 5288215 / Version 00.001 / November 2020 / EN 3 Dairy Farming CE Hereby NEDAP N.V. declares that the subject equipment is in compliance with the directives 2014/53/ EU (Radio Equipment Directive) and 2011/65/EU (Restriction of the use of certain hazardous substances). The full text of the EU declaration of conformity is available at our Business Portal: http://www.nedap.com/ livestockmanagement-portal. Handling instructions Storage If the product is to be stored for some time, make sure that it is under a protective cover to prevent dirt and moisture from entering. Do not expose the product to direct sunlight and / or adverse weather conditions such as storm, rain, hail or snow. See Summary technical specications for the storage temperature range and relative humidity. Disposal The owner or last user of the product is responsible for the proper disposal of (parts of) the product according to local rules and regulations. The WEEE symbol in Europe indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive WEEE 2012/19/EU). Warranty and spare parts Please consult the Nedap products dealer from whom you purchased this product, in regards to the applicable warranty conditions. This product cannot be used for any other purpose as described in this document. If the product is not installed according to this document; the warranty provided is not applicable. At the sole discretion of Nedap N.V., Nedap N.V. may decide to change the conditions of the warranty policy. You agree that Nedap N.V. is able to compensate you the pro-rata value of the warranty involved rather than replacing or repairing the product depending on the technical or economical value of the product. Prior to applying the warranty, please verify if you comply with the warranty conditions of the warranty policy, whether you can successfully apply for the replacement or repair of a defective part. Parts can only be replaced with original Nedap parts, otherwise the warranty policy will not be applicable on the product. If the warranty is applicable, please contact the dealer or send the defective parts to the dealer. Copyright and Disclaimer Copyright Nedap N.V., Parallelweg 2, NL-7141 DC Groenlo, The Netherlands. This document is property of Nedap N.V. and the content is not to be reproduced in any way, in whole or in part, without the prior written consent of Nedap N.V. Nedap N.V. makes no representations or warranties whether express or implied as to the accuracy, correctness, completeness of this document. If this document is part of the installation manual, the installation manual will be leading. You use the products at your own risk. Nedap N.V. reserves the right to make changes to this document and/or the products described. Please consult the Nedap Livestock Management business portal (www.nedap.com/livestockmanagement-portal) for any changes or notication. Parallelweg 2 NL-7141 DCGroenlo The Netherlands