FCC ID: CGDVP1105B VP1105-B

Instruction Manual VP1105-B Safety Instructions Version 01.000 / June 2020 / EN Original instructions Livestock Management Copyright Copyright Nedap N.V. All rights reserved. The information in this document is subject to change without notice, it is not to be reproduced in any way, in whole or in part, without the written consent of Nedap N.V. All trademarks referenced belong to their respective owners. Disclaimer Nedap N.V. has made every effort to ensure the accuracy of the information contained in this document. However, Nedap N.V. makes no representations or warranties whatsoever whether express or implied as to the accuracy, correctness, completeness or t-for-purpose or suitability for the purpose of this product. You use the products at your own risk. Nedap N.V. excludes any liability to the maximum extent permitted by applicable law for the damages caused by errors or failures made during the installation or improper use of this product or by not applying the instructions stated in this document. Nedap N.V. reserves the right to make improvements or amendments to this document and/or the products described therein at any time without any notication. The latest version of this document can be found on the Nedap Livestock Management business portal (www.nedap.com/livestockmanagement-portal). Please download the latest version of this document (by yourself or reseller) and keep a copy for your own records. This document can be published in various languages but only the English language version will prevail. Nedap N.V. assumes no responsibility for any errors caused for the translations into another language. Warranty and spare parts Please consult the Nedap products dealer from whom you purchased this product, in regards to the applicable warranty conditions. This product cannot be used for any other purpose as described in this document. If the product is not installed according to this document; the warranty provided is not applicable. At the sole discretion of Nedap N.V., Nedap N.V. may decide to change the conditions of the warranty policy. You agree that Nedap N.V. is able to compensate you the pro-rata value of the warranty involved rather than replacing or repairing the product depending on the technical or economical value of the product. Prior to applying the warranty, please verify if you comply with the warranty conditions of the warranty policy, whether you can successfully apply for the replacement or repair of a defective part. Parts can only be replaced with original Nedap parts, otherwise the warranty policy will not be applicable on the product. If the warranty is applicable, please contact the dealer or send the defective parts to the dealer. Additional information For any information or questions regarding the product, please contact your own dealer. The installation manual for this product can be found at: www.nedap.com/livestockmanagement-portal 1 Safety Read this manual before using this product. Failure to follow the instructions and safety precautions in this manual may result in serious injury or death. Keep this manual in a safe location for future reference. Symbols used in the manual Danger Warning Caution Indicates a hazardous situation that, if not avoided, will result in death or serious injury. Indicates a hazardous situation that, if not avoided, could result in death or serious injury. Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. Indicates important information but not hazard related. Suggestions and advice to perform certain tasks more easily. General safety instructions Warning Always turn off the mains power supply when working on the electrical installation. Warning Always wear proper protection when installing and maintaining the VP1105-B. Caution Use the VP1105-B only with a suitable power supply. The power supply or power adapter must comply with local regulations for a SELV, limited power (NEC class2, ps2) output (e.g. Nedap VP2001-B). Caution Installation and service should only be done by locally qualied personnel. Caution Install the system according to the local rules and regulations. Working environment Caution The installation area must be free from any obstacles, including animals. VP1105-B / Safety Instructions Version 01.000 / June 2020 / EN 1 Livestock Management Animal welfare and safety The automated actions of the Nedap Livestock Management systems do never discharge the installer and the user of the system from his/her responsibility to assure and to take care of the well-being of the animals. VP1105-B / Safety Instructions Version 01.000 / June 2020 / EN 2 Livestock Management 2 Technical specifications VP1105-B Item Weight Power supply Input current Cable length Dimensions (L x W x H) 190 x 140 x 45 mm (7.48 x 5.51 x 1.77 in.) Specication 1.3 kg (2.87 lb) The power supply or power adapter must comply with local regulations for a SELV, limited power (NEC class2, ps2) output (e.g. Nedap VP2001 or Nedap power adapter part no. 9223126). Power supply input voltage 25 VDC, +20% -20%

Power consumption, maximum 3.5 W (normal antenna power) 7 W (Antenna Power Boost) Max. 350 mA ca. 4 m (13.12 ft) Operating temperature range

-10 to 50 C (14 to 122 F) Storage temperature range

-20 to 70 C (-4 to 158 F) Relative humidity

< 93% (non-condensing) @ -20 to 70 C (-4 to 158 F) Enclosure protection class IP67 Complies with ISO 11784 / 11785 VP1105-B / Safety Instructions Version 01.000 / June 2020 / EN 3 Livestock Management 3 Compliance FCC/IC This device complies with part 15 of the FCC Rules and to RSS of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Cet appareil se conforme aux normes RSS exempts de license du Industry Canada. L'opration est soumis aux deux conditions suivantes:(1) cet appareil ne doit causer aucune interfrence, et (2) cet appareil doit accepter n'importe quelle interfrence, y inclus interfrence qui peut causer une operation non pas voulu de cet appareil. Les changements ou modications n'ayant pas t expressment approuvs par la partie responsable de la conformit peuvent faire perdre l'utilisateur l'autorisation de faire fonctionner le matriel. FCC/ISED Radiation Exposure Statement This equipment complies with FCC and Canadian radiation exposure limits set forth in RSS-102 for a controlled environment. This equipment should be installed and operated with a minimum distance of 3.5 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet quipement est conforme a RSS limites nonces pour un environnement non contrl. Cet quipement doit tre install et utilis avec une distance minimale de 3,5 cm entre le radiateur et votre corps. ISED EMC Declaration This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de Classe B est conforme la norme Canadienne ICES-003. symbol in Europe indicates that the relevant electrical product or battery should not be disposed The WEEE of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive WEEE 2012/19/EU). Disposal CE Hereby NEDAP N.V. declares that the subject equipment is in compliance with the directives 2014/53/EU(Radio Equipment Directive) and 2011/65/EU (restriction of the use of certain hazardous substances). The full text of the EU declaration of conformity is available at our Business Portal: www.nedap.com/livestockmanagement-

portal. Parallelweg 2 NL-7471 DCGroenlo The Netherlands

Nedap N.V. Parallelweg 2 7141 DC Groenlo The Netherlands June 23, 2020 Subject: Confidentiality Request for FCC ID: _CGDVP1105B and IC: 1444A-VP1105B Pursuant to FCC 47 CRF 0.457(d) and 0.459 and IC RSP-100, Section 10, the applicant requests that a part of the subject FCC/IC application be held confidential. T: +31 (0)544 471 111 info@nedap.com www.nedap.com Type of Confidentiality Requested Short Term Permanent Short Term Permanent Short Term Permanent Exhibit Block Diagrams Operation Description/Theory of Operation Schematics Nedap N. V. has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality:

The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public. Short-Term Confidentiality:

The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of 180 days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify TUV Rheinland in the event information regarding the product or the product is made available to the public. TUV Rheinland will then release the documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. Sincerely, By:

(Signature/Title) Compliance Manager Reinold Hubers____

(Print name) Trade register: 08013836 | IBAN: NL08 ABNA 0453299555 | BIC: ANBNANL2A | VAT: NL006456285B01 The General Terms and Conditions of ICT-Office apply to all our offers and agreements. These conditions can be found at our website and can be provided upon request.