FCC ID: G6D530H QUALITY TOYS NEWABRIGH Ty Tl ee LY FULL FUNCTION RADIC CONTROL NO. 530-2 Battery Requiremenis:
Transmitter: One 9V Alkaline Battery Vehicle: 6.0V Rechargeahle Power Pack/Charger User cannot modify this product.
[J Controller and Vehicle ANTENNAS are packed in shipping foam in box. LO PU UA IN GOD FF Ne 1. Push antenna wire AN 2. Insert tube into ZX then, ab hel... ache I Popo leo Howe Ol Vemicie. 3. A knot may be tied at the top. S Screw antenna in tightly
. a for best transmission. a Be sure the + and - are NOTE: FOR BEST PERFORMANCE ALWAYS USE ALKAUNE BATTERIES. properly matched. Slide the power pack into the battery compartment. Following the direction of the arrow inside the battery compartment.}
rower Bucket Button SY Vehicle Operation Button Press Fower bucxcl bution 4, once fo activate rower DUCKS! Operanol,. The working safetylight on the vehicle will start blinking when Power Bucket Button @ is pressed. POWER ARM:
* Move joystick @) upward to lift the power arm. e@ Mave javetick (8) downward to lower the power arm. I Na POWER BUCKET:
* Move joystick @) upward to dump.
* Move joystick @) downward to scoop. Press Vehicle Operation Button @) once to stop blinking light. Tha vahicin ic racuumad ta vehicle oneration mode. ae Turn ON/OFF switch on vehicle to the ON position for power. After play, always turn vehicle off. Remove 9V" batiery and rechargeable pack when not in use or when stored. Leakage may occur and cause damage if left for a period of time. Power Bucket Vehicle Button Operation Button Press Vehicle Operation Button 1) once to activate Vehicle Operation mode. FORWARD STEERING:
Move joystick @) upward to steer right in forward drive.
* Move joystick @) upward to steer left in forward drive.
* Move joystick @) and @) upward together for straight, forward drive. REVERSE STEERING:
* Move joystick @) downward to steer left in reverse drive.
* Move joystick @) downward to steer right in reverse drive.
* Move joystick @ and (3) downward together for straight, reverse drive. Radio waves control and drive the vehicle. Any of the following conditions may interfere with the behavior and function. The transmitter signals can easily be interrupted, caring for your transmitter and vehicle Is 1HUSIraleG on tnese pages. Do not abuse your vehicle!
Remember to avoid water, heat, sand and high impact crashes!
Off road vehicles may run on grassy areas. Eh Miah a we Electronic. instruments ore very sensitive lo direct sunhght Aways vung vol or heat Avoid loag perio ts of play under direct sunlight. [| nway trom |
te and transimiter aa dey cool place sor hot air registers Avoid collisions with hard surfaces
\\ pp Re Avoid running on thick pile carpeting or dusty Hers Avni inning 2 vel tes with the same frequencies Alweiys run one atc time valess you purchase vebicies with different frequencies Save Battery Life Be sure vehicle is turned off when not in play, Contact Installation of Power Pack Slide pack into position following arrows. Be sure contacts are touching and pack is locked into position Weak or Dead Power Pack For best running performance, always start with pack fully charged. Partially charged packs will perform poorly
@\\\\\ ye | 4 wa eS
| ae VONAGE CLL, it a8, QF}
Range Vehicle may go beyond radio signal contact, Loss of Interference control or slowness will be evident when out of range. Erratic behavior, loss of contact or jerking motion may oecur Hold transmitter antenna up high for best reception in areas of high tension wires, Phone poles or CB radios. Wipe body off with a soft rag or tact cloth. Do not clean Brush areas where dirt \ we? \ it vehicle with and dust get trapped. chemicals or water, NEW BRIGHT 6.0 Volt Rechargeable NiCd Power Pack and Charger. an {Sold Separately) Push and Hold Button Up To Remove As Shown 1. Plug charger into a 120V household outlet. 2. Charge the power pack for 4HRS NOTE: Pack is not charged when new. Pack is fully charged after 4hrs of charging, extended charging does not improve running time. Alter charging for hrs, unplug charger and disconnect pack. Running Time Power pack can be charged up to 1,000 times!
Approximate running time is 20 to 30 min. Running time can vary from 10 to 20 min. according to size & weight of vehicle or sneed & terrain Power pack will lose power or quit suddenly. Let pack cool, then recharge after removing pack from vehicle.
* Do not recharge warm or hot power packs. Wait 20 min. until pack nas cooled. Knechurging too early will shorten pack Hfe, Recharging near fire or high temperature is dangerous. Do not recharge packs that show wear or leakage. Always unplug power pack when not in use. Do not dispose pack in fire, explosion or personal injury may occur. Dispose of NiCd power packs properly, do not disassemble. Always remove power pack from vehicle before charging.
| Vo nor use cnarger for any use omer than instructed in directions. |
TROUBLE SHOOTING AND CARE FOR R/C VEHICLES Are the + and s contacts correctly matched in transmitter?
Are the metal contact tabs touching, rusty or dirty in transmitter?
Are there batteries in vehicle and transmitter?
Is the power switch on vehicle turned on?
Is the battery/power pack weak or out of power?
There is radio interference in the area. Another R/C vehicle with the same frequency is close by. The battery is weak or fading. The power pack is worn out and needs to be replaced. Batteries are not Alkaline, are miss matched or are old. TION PARENTS:
The Battery Charger & Battery Pack (sold separately} need to be periodically examined for potential hazards and that any potentially hazardous parts be repaired or replaced.